Read Sharp MX-M260 / MX-M260N / MX-M260FG / MX-M260FP (serv.man5) Service Manual online
MX-M260/M310/M260N/M310N MX-FN13 (Finisher) 5 - 2
6) Remove the paper exit tray by using care for the tray paper presence
detection harness which is connected to the back side of the paper
exit tray.
exit tray.
7) Insert the tray paper presence detection harness into the dummy
connector on the fan duct.
8) Disengage the pawls in the sequence of 1 and 2 and remove the
paper exit dummy cover.
9) Remove the screw, and remove the maintenance cover.
Remove the four screws, and remove the rear cabinet.
10) Remove the screw, and remove the right cabinet lever cover.
11) Open the manual feed tray and the right door.
Remove the two screws, and remove the right cabinet.
12) Pass the harness (packed together with the unit) of the second paper
exit unit though inside of the frame plate as shown in the figure.
Install the second paper exit unit to the machine, and fix it with the
four M4 S tight screws which are packed together with the finisher.
Connect the connector of the harness.
four M4 S tight screws which are packed together with the finisher.
Connect the connector of the harness.
1
2
1
1
2
Click on the first or last page to see other MX-M260 / MX-M260N / MX-M260FG / MX-M260FP (serv.man5) service manuals if exist.