MX-M260, MX-M260N, MX-M260FG, MX-M260FP (serv.man5). Installation Manual. - Sharp Copying Equipment Service Manual (repair manual). Page 14

Read Sharp MX-M260 / MX-M260N / MX-M260FG / MX-M260FP (serv.man5) Service Manual online

MX-M260/M310/M260N/M310N MX-DS11/DS12 (Machine stand) 4 - 2
3) Attach the adjuster covers. 
Put the desk on the floor in the normal state, and open the door.
(MX-DS11 only)
Slide the adjuster covers (2 pcs.) as shown in the figure below and
attach them. Then, close the door.
4) Remove the paper tray.
Pull out the paper feed unit tray from the copier until it stops.
Lift it and remove it from the copier. 
5) Put the copier (or the paper feed unit) on the desk.
Insert the positioning pins (2 pcs.) of the desk into the positioning
holes of the copier (or the paper feed unit). 
At that time, be careful not to break the fixtures on the desk side.
6) Connect the copier with the desk.
Connect the copier with the desk with two screws (P tight, packed
together with the copier) and the fixture.
7) Remove the two screws, and remove the rear cover.
8) Connect the copier (or the paper feed unit) and the desk with two
screws (P tight) and two screws (S tight) packed together with the
copier. When connecting, be careful of the direction of the connect-
ing fixture of the copier.
Front side
Adjuster covers
Adjuster covers
Front side
MX-DS11
MX-DS12
Positioning pin
Positioning pin
Be careful not to hit.
Machine stand
Copier
Fixture
Screws (P tight)
Front side
Screws (P tight)
Back side
Copier 
connecting
fixture
Screws (P tight)
Screws (P tight)
Screws (S tight)
Copier 
connecting
fixture
Screws (S tight)

Display

Click on the first or last page to see other MX-M260 / MX-M260N / MX-M260FG / MX-M260FP (serv.man5) service manuals if exist.

Random: