MX-M260, MX-M260N, MX-M260FG, MX-M260FP (serv.man2). Updated Handy Guide. - Sharp Copying Equipment Handy Guide. Page 17

 

 

 

17 

Test Simulations 

 

 

Perform the following procedure to enter the simulation mode. 
 

     

     

     

 

 
Main code [START] key then Sub code [START] key 
 

 

When the clear all key is pressed, the simulation mode is cancelled. 
When the interruption key is pressed, the process is interrupted and the screen 
returns to the sub code entering display. 
 
After cancelling the simulation mode, be sure to turn OFF/ON the power and check 
the operation. 
 
Note: If the machine is terminated by a jam error or paper empty during copying in 
the adjustment by the simulation, recopying is required. 
 
Note: The values in the simulation columns are not default values but sample values. 
 
 

Main   Sub 

Contents 

01 

01 

Used to check the operation of the scanner unit and its control 
circuit. 

02 

Used to check the operation of sensor and detector in the scanning 
(read) section and the related circuit. 

02 

01 

Used to check the operation of the RSPF unit and the related 
circuit. 

02 

Used to check the operation of sensors and detectors in the RSPF 
unit and the related circuit. 

03 

Used to check the operation of the loads in the RSPF unit and the 
control circuits. 

03 

02 

Used to check the operation of sensor and detector in the finisher 
and the related circuit. 

03 

Used to check the operation of the load in the finisher and the 
control circuit. 

10 

Used to make each adjustment of the finisher.