MX-LC13 (serv.man27). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 66

MX-7500N  MX-LC13 (LARGE CAPACITY TRAYS)  9 – 23

4) Shift the connection unit to the following direction and fix the 2

blue screws.

In case the print image shifts to front;
- Shift the Connection plate unit to the front.
In case the print image shifts to rear: Use F hole.
- Shift the Connection plate unit to the rear.

5) To stick the L-shape driver (Packed items No.12) to the adjust-

ment hole, the connection plate unit position can be adjusted
to the following 4 steps.
F1.5 / 3 : Shift the unit 3 / 1.5 mm to front.
R1.5 / 3 : Shift the unit 3 / 1.5 mm to rear.

6) Reinstall LCT to MX-RB14. 

Use the mark of the rear regulation plate, and fix the blue
screw at the position so that the clearance between paper and
the rear regulation plate is evenly 1mm.
NOTE: Fasten the screw which was unfastened in the proceu-
dre 1).

When shifted over +/-2mm less than +/-3mm.
1)

Pull out the cassette.
Press the lock button on the front cabinet and lower the paper
feed base tray to the paper supply position. Pull out the tray.
* In case the machine is turned off, If it is necessary to release
the lock manually, push the shaft at the bottom of the front cab-
inet and lower the paper feed base tray to the paper supply
position and pull out the tray. 

When shifting the line of printing from the center of the paper in
the direction A of arrow as shown below:

2)

Loosen the blue screws of the rear regulation plate, and move
the plate with referring the carved marks by the dimension
shifted in the direction A (R side), and tighten the blue screws.

3)

Set a sheet of paper on the paper feed base tray and loosen
the blue screws of the front regulation plate.
Move the front regulation plate to the direction A (R side)?with
pushing paper to the front regulation plate.

&RQQHFWLRQSODWHXQLW

5

)

5

)

5HDU

%OXH6FUHZV

5HJXODWLRQ3ODWH

)URQW

3DSHU

3XVKSDSHUWRWKHIURQW
UHJXODWLRQSODWH