MX-LC13 (serv.man15). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 67

MX-7500N  MX-LC13 (LARGE CAPACITY TRAYS)  9 – 24

4) Set the front regulation plate to make gap between the rear

regulation plate and paperand tighten the blue screws of the
fron regulation plate.

NOTE: Avoid bending paper with too much closing the regulation

plates.

NOTE: When shifting the line of printing from the center of the

paper to rear side, move the front regulation plate to adjust
it.

1) Pull out the cassette.

Press the lock button on the front cabinet and lower the paper
feed base tray to the paper supply position. Pull out the tray.
* In case the machine is turned off, If it is necessary to release
the lock manually, push the shaft at the bottom of the front cab-
inet and lower the paper feed base tray to the paper supply
position and pull out the tray. 

2) Adjust the diagonal feed.

3) Set a sheet of paper on the paper feed base tray and adjust

the width of the regulation plate.

In the case of diagonal feed 1
Loosen the 2 blue screw (1) on the front regulation plate.
Referring to the degree of diagonal feed, move the regulation
plate in the clockwize direction and fix the blue screw.

Loosen the 2 blue screws (2) on the rear regulation plate.
To make parallel with the front regulation plate, move the rear
regulation plate in the clockwize direction and fix the screws.

In the case of diagonal feed 2
Loosen the 2 blue screws (1) on the front regulation plate.
Referring to the degree of diagonal feed, move the regulation
plate in the counterclockwize direction and fix the blue screw.

Loosen the 2 blue screws (2) on the rear regulation plate.
To make parallel with the front regulation plate, move the rear
regulation plate in the counterclockwize direction and fix the
screws.

NOTE: When fixing the rear regulation plate, not to fix it more

closely against the paper.
(The target of the gap between the edge of paper and the
rear regulation plate is about 1.0mm)

NOTE: After completion of the adjustment, check that the front reg-

ulation plate and the rear regulation plate are in parallel to
each other.

MM

3DSHU

Diagonal feed 1

Diagonal feed 2

Transport 
direction

)URQW

3DSHU

5HDU

5HJXODWLRQ3ODWH

)URQW

3DSHU

5HDU

5HJXODWLRQ3ODWH

TopPage

: ‘14/Jan