MX-LC13 (serv.man15). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 43

Read Sharp MX-LC13 (serv.man15) Technical Bulletin online

MX-7040N  MX-LC13 (LARGE CAPACITY TRAYS)  8 – 24
In the case of diagonal feed 2
Loosen the 2 blue screws (1) on the front regulation plate.
Referring to the degree of diagonal feed, move the regulation
plate in the counterclockwize direction and fix the blue screw.
Loosen the 2 blue screws (2) on the rear regulation plate.
To make parallel with the front regulation plate, move the rear
regulation plate in the counterclockwize direction and fix the
screws.
NOTE: When fixing the rear regulation plate, not to fix it more
closely against the paper.
(The target of the gap between the edge of paper and the
rear regulation plate is about 1.0mm)
NOTE: After completion of the adjustment, check that the front reg-
ulation plate and the rear regulation plate are in parallel to
each other.
J. Fixation of LC13
In order to avoid the unstable installation, underlay the adjustment
bolt with the adjuster and fix LC13 to the floor.
NOTE: Fix the right side adjuster not to change the height level of
LC13 largely.
NOTE: If the fixation of LC13 is unstable, it might be moved when
insert the tray to the unit.
1)
K. Height Adjustment
If there’s some gap between cabinets or door adjustment is neces-
sary, adjust the height adjustment.
1)
Install the adjuster (Packed items No.3) and adjuste the height
of LC13 (4 places)
2)
Adjust height in order to make the gap evenly of  each cabinet
as the figure below.
3)
Adjust height in order to make the height and the gap evenly of
each cabinet as the figure below.
NOTE: When installing this machine in a place of low atmospheric
pressure, check and conform to the adjustment contents in
the MX-LC13 Service Manual.
)URQW
3DSHU
5HDU
5HJXODWLRQ3ODWH
TopPage
5
: ‘14/Jan
5
Page of 68
Display

Click on the first or last page to see other MX-LC13 (serv.man15) service manuals if exist.