Read Sharp MX-FNX5 Service Manual online
MX-FNX5 REPLACEMENT AND ADJUSTMENT 3 – 5
E. ENTRANCE AND STAPLER TRAY ENTRANCE
SENSORS
(1) Entrance Sensor
1)
Disconnect the finisher from the copier.
2)
Remove the sensor bracket [A] ( x 1).
3)
Replace the entrance sensor [B] ( x 1) (
x 1).
(2) Stapler Tray Entrance Sensor
1)
Open the front door.
2)
Remove the sensor bracket [C] ( x 1).
3)
Replace the stapler tray entrance sensor [D] ( x 1)(
x 1).
F. MAIN BOARD, PRE-STACK PAPER SENSOR
1)
Remove the rear cover. (
1. COVERS -D.)
2)
Remove the main board bracket ( x6,
x8,
x All).
3)
Open the front door.
4)
Loosen the screw [A] ( x1)
Remove:
[B] Gear cover ( x1)
[C] Gear (
[B] Gear cover ( x1)
[C] Gear (
x1, Timing belt x1)
[D] Gear (
x1)
[E] Plate ( x2)
[F] Left vertical transport guide
[G] Middle vertical transport guide
[H] Pre-stack paper sensor (
[F] Left vertical transport guide
[G] Middle vertical transport guide
[H] Pre-stack paper sensor (
x1)
[B]
[A]
[D]
[C]
[A]
[B]
[C]
[D]
[E]
Click on the first or last page to see other MX-FNX5 service manuals if exist.