Read Sharp MX-FN26 Service Manual online
MX-FN26 N OPERATIONAL DESCRIPTIONS 6 – 1
[6] OPERATIONAL DESCRIPTIONS
1. General
This chapter describes the operations of the finisher.
The major operation modes are as follows:
• Offset mode
• Staple mode
In this chapter, the basic operations in the above two modes are described.
2. Outline of the transport path
The outline of the transport path is described below.
3. Offset mode
When the operation mode command is received from the copier,
the finisher starts the transport operation.
the finisher starts the transport operation.
A. Reception of paper discharged from the main
unit
1)
The paper delivery motor (FPDM) is driven in the paper deliv-
ery direction to lift the take-up roller. When a flapper solenoid
request (finisher paper pass) is received, the paper gate sole-
noid (FPGS) is turned ON to switch the paper pass gate to the
finisher side.
ery direction to lift the take-up roller. When a flapper solenoid
request (finisher paper pass) is received, the paper gate sole-
noid (FPGS) is turned ON to switch the paper pass gate to the
finisher side.
2)
When paper enters the finisher, the paper transport motor
(FPTM) is driven at the machine paper delivery speed to
receive paper delivery from the machine.
(FPTM) is driven at the machine paper delivery speed to
receive paper delivery from the machine.
3)
When the rear edge of paper passes the paper delivery roller
of the machine, the paper transport motor (FPTM) is acceler-
ated to 400mm/sec. After a lapse of a certain time, the paper
alignment motor F (FPAM-F) and the paper alignment motor R
(FPAM-R) are driven to make the paper alignment plate stand
by outside of paper. Then, the alignment roller lift solenoid
(FARLS) is turned ON to lift the rear edge take-up roller.
of the machine, the paper transport motor (FPTM) is acceler-
ated to 400mm/sec. After a lapse of a certain time, the paper
alignment motor F (FPAM-F) and the paper alignment motor R
(FPAM-R) are driven to make the paper alignment plate stand
by outside of paper. Then, the alignment roller lift solenoid
(FARLS) is turned ON to lift the rear edge take-up roller.
No.
Name
No.
Name
1
Delivery movable tray
8
Paper pass detector
2
Paper delivery tray paper detector
9
Paper pass gate
3
Delivery paddler
10
Stapler
4
Paper delivery roller
11
Rear edge plate
5
Take-up roller
12
Paper rear edge detector
6
Paper alignment plate (F, R)
13
Rear edge take-up roller
7
Paper pass roller
14
Paper level actuator
4
5
7
10
3
1
6
11
12
13
14
2
8
9
Click on the first or last page to see other MX-FN26 service manuals if exist.