MX-FN19, MX-FN20, MX-PN12. All Sections - Sharp Copying Equipment Specification (repair manual). Page 26

MX-FN19  MAINTENANCE  4 – 9

3) Remove the two screws [6], and open the harness holder [7] at

three positions, and disconnect the connectors [8] at two posi-
tions.

4) Insert your finger into the hole in the back of the No. 1 tray [9],

and push the tray lift motor gear [10] toward you to release the
clutch, and lift the No. 1 tray [9].

CAUTION: When the clutch of the tray lift motor gear is released, it

falls by its own weight. When releasing the clutch,
therefore, hold the tray at the bottom in advance. When
installing it, take care not to twist the tray cable.

CAUTION: Note for installing or moving the tray

When moving down the tray, push up the shutter [1],
and release the latch [2] on the lower surface of the tray
to lower the tray.
When the latch is released, the tray will free-fall. Hold
the tray with your hand during the removal.

1)

Remove the screw [1], and remove the stopper [2].

2)

Remove the two screws [3], and disconnect the connector [4].

3)

Insert your finger into the hole in the back of the No. 2 tray [5].
Push the tray lift motor gear [6] toward you to release the
clutch, and lift the No. 2 tray [5].

CAUTION: When the clutch of the tray lift motor gear is released, it

falls by its own weight. When releasing the clutch,
therefore, hold the tray at the bottom in advance so as
not to twist the tray cable.

[7]

[8]

[6]

[6]

[9]

[10]

[2]

[1]

[2]

[1]

[4]

[3]

[3]

[5]

[6]