Read Sharp MX-BMX1 (serv.man3) Service Manual online
BF-3-7
Replacement
Adjustment
20 October 2010
COVERS
3.1.6 TILT THE MACHINE
Removal
1. Remove Belt stacker ( Service manual MX-BMX1
1. Remove Belt stacker ( Service manual MX-BMX1
3.8.1).
2. Remove the Trim bin.
3. Remove the Service bracket [A] by removing two nuts ( x 2 ).
4. Remove the foot screw [C] and mount it in the oposite hole up-side-down.
5. Place the Service bracket [B] in the Book folder base.
6. Turn foot screw [C] on the Service bracket, until the Service bracket firmly
contacts the floor.
7. Remove the screw [D] securing the machine with the base.
8. Remove Front cover (
8. Remove Front cover (
3.1.1).
9. Remove Rear cover (
3.1.2).
10. Loosen screws [E] half a turn. One on each side ( x 2).
[A]
[B]
[C]
[D]
WARNING
Book Folder may Tip. Install Service bracket before separating the Book
Folder from the Trimmer.
Folder from the Trimmer.
WARNING
Before tilting make sure pivot screws [E] are NOT tightened.
Infeed view
Infeed view
from below
Click on the first or last page to see other MX-BMX1 (serv.man3) service manuals if exist.