Read Sharp MX-BMX1 (serv.man3) Service Manual online
BF-3-4
20 October 2010
COVERS
3.1.4 OUTFEED COVER
[A]
Removal
1. Remove Top cover gas spring lower end from joint [A].
1. Remove Top cover gas spring lower end from joint [A].
NOTE: Press plastic stud from pivot point.
2. Loosen screws [B] ( x 2).
3. Remove screws [C] ( x 2).
4. Remove upper part of outfeed cover.
5. Remove Belt Stacker hangers and washers [D] ( x 2, x 2).
6. Remove screws [E] ( x 2).
7. Remove screws and washers [F] ( x 2, x 2).
8. Lift Out feed cover plates carefully and disconnect wiring to sensor Q7 Pho-
3. Remove screws [C] ( x 2).
4. Remove upper part of outfeed cover.
5. Remove Belt Stacker hangers and washers [D] ( x 2, x 2).
6. Remove screws [E] ( x 2).
7. Remove screws and washers [F] ( x 2, x 2).
8. Lift Out feed cover plates carefully and disconnect wiring to sensor Q7 Pho-
totransistor [G] (
x 1).
9. Remove lower part of outfeed cover.
[B]
[D]
[C]
[F]
[E]
Click on the first or last page to see other MX-BMX1 (serv.man3) service manuals if exist.