Read Sharp MX-B200 (serv.man8) User Guide / Operation Manual online
9
80
MISFEED REMOVAL
When the misfeed (
) indicator blinks or
blinks in the display, the unit will
stop because of a misfeed. When the SPF misfeeds an original sheet, the unit will
stop and the SPF misfeed (
stop and the SPF misfeed (
) indicator will blink, while the misfeed (
) indicator
will remain off. For a misfeed of originals in the SPF, see "E: Misfeed in the SPF
(Peripheral device)" (p.84).
(Peripheral device)" (p.84).
1
Open the multi-bypass tray,
and then open the side
cover.
and then open the side
cover.
2
Check the misfeed location.
Remove the misfed paper following the instructions for each
location in the illustration below. If the misfeed (
Remove the misfed paper following the instructions for each
location in the illustration below. If the misfeed (
) indicator
blinks, proceed to "A: Misfeed in the paper feed area" (p.81).
While pressing the start
(
(
) key, "64" is displayed.
Check the toner cartridge and make sure that the
seal is not still affixed.
seal is not still affixed.
–
Indication
Cause and remedy
Page
If the misfed paper is seen from this
side, proceed to "C: Misfeed in the
transport area" (p.83).
side, proceed to "C: Misfeed in the
transport area" (p.83).
If paper is misfed here, proceed to
"B: Misfeed in the fusing area" (p.82).
"B: Misfeed in the fusing area" (p.82).
If paper is misfed here, proceed to
"A: Misfeed in the paper feed area" (p.81).
"A: Misfeed in the paper feed area" (p.81).
If paper is misfed here, proceed to
"D: Misfeed in the lower paper feed
area (Peripheral device)" (p.83).
"D: Misfeed in the lower paper feed
area (Peripheral device)" (p.83).
Click on the first or last page to see other MX-B200 (serv.man8) service manuals if exist.