CFD-E70L - Sony Audio Service Manual (repair manual)

cfd-e70l service manual
Model
CFD-E70L
Pages
56
Size
3.59 MB
Type
PDF
Document
Service Manual
Brand
Device
Audio
File
cfd-e70l.pdf
Date

Read Sony CFD-E70L Service Manual online

SERVICE MANUAL
CD RADIO CASSETTE-CORDER
AEP Model
UK Model
CFD-E70L
Ver 1.1  2002.07
9-873-576-02
Sony Corporation
2002G0500-1
Personal Audio Company
C
 2002.07
Published by Sony Engineering Corporation
SPECIFICATIONS
CD
Model Name Using Similar Mechanism
CFD-E75L
Section
CD Mechanism Type
KSM-213CDP
Optical Pick-up Name
KSS-213C
TAPE
Model Name Using Similar Mechanism
CFD-E75L
Section
Tape Transport Mechanism Type
MF-V5-117
CD player section
System
Compact disc digital audio system
Laser diode properties
Material: GaAlAs
Wave  length: 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 
µW
(This output is the value measured at a distance of about
200 mm from the objective lens surface on the optical
pick-up block with 7 mm aperture.)
Spindle speed
200 r/min (rpm) to 500 r/min (rpm) (CLV)
Number of channels
2
Frequency response
20 - 20 000 Hz +0/–1 dB
Wow and flutter
Below measurable limit
Radio section
Frequency range
FM
87.5 - 108 MHz
MW
531 - 1 602 kHz (9 kHz step)
530 - 1 610 kHz (10 kHz step)
LW
153 - 279 kHz
IF
FM: 10.7 MHz
MW/LW: 450 kHz
Aerials
FM: Telescopic aerial
MW/LW: Built-in ferrite bar aerial
Cassette-corder section
Recording system
4-track 2 channel stereo
Fast winding time
Approx. 120 sec. with Sony cassette C-60
Frequency response
TYPE I (normal): 70 - 13 000 Hz
General
Speaker
Full range: 8 cm (3 
1
 in.) dia.,
Ω, cone type (2)
Outputs
Headphones jack (stereo minijack)
For 16 - 64 
Ω impedance headphones
Maximum power output
4 W
Power requirements
For CD radio cassette-corder:
230 V AC, 50 Hz
9 V DC, 6 R14 (size C) batteries
For memory back-up:
4.5 V DC, 3 R6 (size AA) batteries
Power consumption
 AC 14 W
Battery life
For CD radio cassette-corder:
FM recording
Sony R14P: approx. 5 h
Sony alkaline LR14: approx. 20.5 h
Tape playback
Sony R14P: approx. 6 h
Sony alkaline LR14: approx. 27 h
CD playback
Sony R14P: approx. 1.5 h
Sony alkaline LR14: approx. 8 h
Dimensions
Approx. 283 
× 165 × 281  mm  (w/h/d)
(11 
1
4
 
× 6 
1
2
 
× 11 
1
 inches)
 
(incl. projecting parts)
Mass
Approx. 3.5 kg (7 lb. 11 oz) (incl. batteries)
Supplied accessories
Mains lead (1)
Design and specifications are subject to change without
notice.
2
CFD-E70L
TABLE  OF  CONTENTS
1.
SERVICING  NOTES
..............................................
3
2.
GENERAL
..................................................................
4
3.
DISASSEMBLY
3-1. Disassembly Flow ...........................................................
7
3-2. Cabinet Lower Assy ........................................................
8
3-3. AC INLET Board, Power Board .....................................
8
3-4. TUNER Board, MAIN Board .........................................
9
3-5. Cover Plate Assy .............................................................
9
3-6. CD Mechanism Deck (KSM-213CDP) .......................... 10
3-7. Optical Pick-up (KSS-213C) .......................................... 10
3-8. Cabinet Front Assy .......................................................... 11
3-9. Tape Mechanism Deck (MF-V5-117) ............................ 11
3-10. CD Lid ............................................................................. 12
3-11. Lid Cassette Assy, LCD Board ....................................... 12
3-12. Head (HRP301), Motor Assy (M301), Belt ................... 13
3-13. Connector Setting ............................................................ 13
4.
MECHANICAL  ADJUSTMENTS
...................... 14
5.
ELECTRICAL  ADJUSTMENTS
Tape Deck Section ......................................................... 14
Tuner Section ................................................................. 15
CD Section .....................................................................  17
6.
DIAGRAMS
6-1. Block Diagram  – CD Section – .................................... 19
6-2
Block Diagram  – TUNER Section – ............................ 20
6-3. Block Diagram  – MAIN Section – ............................... 21
6-4. Block Diagram  – POWER SUPPLY Section – ............ 22
6-5. Note for Printed Wiring Boards and
Schematic Diagrams ...................................................... 23
6-6
Printed Wiring Board  – CD Section – .......................... 24
6-7. Schematic Diagram  – CD Section – ............................. 25
6-8. Printed Wiring Board  – TUNER Section – .................. 26
6-9. Schematic Diagram  – TUNER Section – ..................... 27
6-10. Printed Wiring Board  – TAPE DECK Section – .......... 28
6-11. Schematic Diagram  – TAPE DECK Section – ............. 28
6-12. Printed Wiring Boards  – MAIN/LCD Boards – ........... 29
6-13. Schematic Diagram  – MAIN Board (1/2) – ................. 30
6-14. Schematic Diagram  – MAIN (2/2)/LCD Boards – ...... 31
6-15. Printed Wiring Boards  – PANEL Section – ................. 32
6-16. Schematic Diagram  – PANEL Section – ...................... 33
6-17. Printed Wiring Boards
– POWER SUPPLY Section – ....................................... 34
6-18. Schematic Diagram
– POWER SUPPLY Section – ....................................... 35
6-19. IC Pin Function Description .......................................... 39
7.
EXPLODED  VIEWS
7-1. Cabinet Section ............................................................... 41
7-2. Cabinet Upper Section .................................................... 42
7-3. Cabinet Front Section ..................................................... 43
7-4. Cabinet Lower Section .................................................... 44
7-5. Optical Pick-up Section (KSM-213CDP) ...................... 45
7-6. Tape Mechanism Deck Section-1 (MF-V5-117) ............ 46
7-7. Tape Mechanism Deck Section-2 (MF-V5-117) ............ 47
8.
ELECTRICAL  PARTS  LIST
.............................. 48
SAFETY-RELATED  COMPONENT  WARNING!!
COMPONENTS  IDENTIFIED  BY  MARK  
0
  OR  DOTTED
LINE  WITH  MARK  
0
  ON  THE  SCHEMATIC  DIAGRAMS
AND  IN  THE  PARTS  LIST  ARE  CRITICAL  TO  SAFE
OPERATION.  REPLACE  THESE  COMPONENTS  WITH
SONY  PARTS  WHOSE  PART  NUMBERS  APPEAR  AS
SHOWN  IN  THIS  MANUAL  OR  IN  SUPPLEMENTS  PUB-
LISHED  BY  SONY.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
This Compact Disc player is classified as a
CLASS 1 LASER product.
The CLASS 1 LASER PRODUCT label is located
at the rear.
3
CFD-E70L
SECTION  1
SERVICING  NOTES
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES  ON  LASER  DIODE  EMISSION  CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
LASER DIODE AND FOCUS SEARCH OPERATION
CHECK
During normal operation of the equipment, emission of the laser
diode is prohibited unless the upper lid is closed while turning ON
the S901. (push switch type)
The following checking method for the laser diode is operable.
• Method
Emission of the laser diode is visually checked.
1. Open the upper lid.
2. Push the S901 as shown in Fig.1.
Note:
 Do not push the detection lever strongly, or it may be bent or dam-
aged.
3. Press the 
[     ]
 (CD) button.
4. Check the object lens for confirming normal emission of the
laser diode. If not emitting, there is a trouble in the automatic
power control circuit or the optical pick-up.
In this operation, the object lens will move up and down 2
times along with inward motion for the focus search.
NOTES  ON  HANDLING  THE  OPTICAL  PICK-UP
BLOCK  OR  BASE  UNIT
CHUCK  PLATE  JIG  ON  REPAIRING
On repairing CD section, playing a disc without the CD lid, use
Chuck Plate Jig.
• Code number of Chuck Plate Jig: X-4918-255-1
u
S901
Fig.1 Method to push the S901
About CD-Rs/CD-RWs
This player is compatible with CD-Rs/CD-RWs but
playback capability may vary depending on the quality of
the disc, the recording device and application software.
4
CFD-E70L
SECTION  2
GENERAL
This section is extracted from
instruction manual.
4
GB
Connect the supplied mains lead (see page 24).
1
Press ZPUSH OPEN/CLOSE down
to open the CD compartment and
place the CD on the CD
compartment.
2
Close the lid of the CD compartment.
3
Press u
The player turns on (direct power-on)
and plays all the tracks once.
Basic Operations
3
Playing a CD
Display
With the label side up
1, 2
PUSH OPEN/CLOSE
PUSH OPEN/CLOSE
Playing time
Track number
Basic 
Operations
5
GB
Use these buttons for additional operations
OPERATE
x
u
Jog dial
VOLUME +, –
Z
PUSH
OPEN/CLOSE
To
Do this
adjust the volume
Press VOLUME +, –. 
stop playback
Press x.
pause playback
Press u.
Press the button again to resume
play after pause.
go to the next track
Turn the jog dial clockwise.
go back to the previous track Turn the jog dial counterclockwise.
remove the CD
Press ZPUSH OPEN/CLOSE.
turn on/off the player
Press OPERATE. 
6
GB
Listening to the radio
Connect the supplied mains lead (see page 24).
1
Press RADIO BAND•AUTO
PRESET until the band you want
appears in the display (direct power-
on).
Each time you press the button, the
band changes as follows:
2
Hold down TUNE + or – until the
frequency digits begin to change in
the display.
The player automatically scans the
radio frequencies and stops when it
finds a clear station.
If you can't tune in a station, press
the button repeatedly to change the
frequency step by step.
Display
Indicates an FM stereo
broadcast
1
2
RADIO
AUTO PRESET
BAND
TUNE
“FM” t “MW” t “LW”
Basic 
Operations
7
GB
Use these buttons for additional operations
To
Press
adjust the volume
VOLUME +, –
turn on/off the radio
OPERATE
To  improve broadcast reception
Reorient the aerial for FM. Reorient the player itself for
MW/LW. 
for FM
for MW/LW
Tips
• If the FM broadcast is
noisy, press MODE until
“Mono” appears in the
display and the radio will
play in monaural.
• If you need to change the
MW tuning interval,
see page 25.
OPERATE
VOLUME +, –
MODE
Page of 56
Display

Download Sony CFD-E70L Service Manual (Repair Manual)

Here you can read online and download Sony CFD-E70L Service Manual in PDF. CFD-E70L service manual will guide through the process and help you recover, restore, fix, disassemble and repair Sony CFD-E70L Audio. Information contained in service manuals typically includes schematics / circuit diagrams, wiring diagrams, block diagrams, printed wiring boards, exploded views, parts list, disassembly / assembly, pcb.