Read Sharp MX-6580N / MX-7580N (serv.man3) Service Manual online
MX-7580N ADJUSTMENTS AND SETTINGS 5 – 62
7)
In the case of tandem tray
Loosen two red screws, and adjust the position of the paper
feed guide.
feed guide.
8)
In the case of paper feed tray 3/4
Loosen the paper feed tray off-center adjustment screws (2
pcs.) at the center section of the lift plate of the paper feed tray,
and change the gear unit position in the front/rear frame direc-
tion. Repeat the adjustment procedures from 4).
pcs.) at the center section of the lift plate of the paper feed tray,
and change the gear unit position in the front/rear frame direc-
tion. Repeat the adjustment procedures from 4).
NOTE:
The adjustment item (SUB-XXX-HV-XXX) is used to make the fine
adjustment of heavy paper/OHP/envelopes for the adjustment item
(SUB-XXX) of each paper feed tray.
adjustment of heavy paper/OHP/envelopes for the adjustment item
(SUB-XXX) of each paper feed tray.
ADJ 14
Scan image magnification ratio
adjustment
(Manual adjustment)
adjustment
(Manual adjustment)
14-A
Scan image magnification ratio adjustment
(main scanning direction) (Manual
adjustment) (Document table mode)
(main scanning direction) (Manual
adjustment) (Document table mode)
CAUTION: If the default adjustment value of the scan image magni-
fication ration adjustment (main scanning direction) of
SIM 48-1, copy image quality may be degraded. There-
fore, this adjustment must be executed only when there
is a special necessity.
SIM 48-1, copy image quality may be degraded. There-
fore, this adjustment must be executed only when there
is a special necessity.
This adjustment must be performed in the following cases:
* When the copy magnification ratio in the copy image main scan-
ning direction is not properly adjusted.
* When the scanner motor is replaced.
* U2 trouble has occurred.
* When the scanner control PWB is replaced.
* When the EEPROM of the scanner control PWB is replaced.
Before this adjustment, the focus adjustment (CCD unit installing
position adjustment) must have been completed.
position adjustment) must have been completed.
1)
Place a scale on the document table as shown in the figure
below.
below.
2)
Enter the SIM 48-1 mode.
3)
Make a normal copy and obtain the copy magnification ratio.
Press [CLOSE] key to shift from the simulation mode to the
copy mode, and make a copy.
copy mode, and make a copy.
4)
Check that the copy magnification ratio is within the specified
range (100 +/- 0.5%).
range (100 +/- 0.5%).
If the copy magnification ratio is within the specified range (100
+/- 0.5%), the adjustment is completed. If the copy magnifica-
tion ratio is not within the specified range, perform the follow-
ing procedure.
+/- 0.5%), the adjustment is completed. If the copy magnifica-
tion ratio is not within the specified range, perform the follow-
ing procedure.
5)
Change the CCD (MAIN) adjustment value of Simulation 48-1.
When the adjustment value is increased, the copy magnifica-
tion ratio is increased.
tion ratio is increased.
When the adjustment value is changed by 1, the copy magnifi-
cation ratio is changed by about 0.02%.
cation ratio is changed by about 0.02%.
Repeat the procedures 3) - 5) until the copy magnification ratio
is within the specified range (100 +/- 0.5%).
is within the specified range (100 +/- 0.5%).
Click on the first or last page to see other MX-6580N / MX-7580N (serv.man3) service manuals if exist.