Read Sharp MX-6201N / MX-7001N (serv.man39) Service Manual online
MX-7001N FUSING SECTION O – 20
o. Web unit
1)
Remove the fusing unit. (Refer to the "(1) Fusing unit".)
2)
Remove the screws (A). Rotate the fusing web unit (B), and
remove it.
* When installing, engage the fusing web unit (B) to the pawls
remove it.
* When installing, engage the fusing web unit (B) to the pawls
(C) of the upper cover.
* When installing, be careful to prevent bending the electrode
(D), and check that the electrode is contacted.
3)
Remove the screw (E), and remove the bearing (F).
4)
Remove the wind-up side (G) of web unit. Remove the collar
(H).
(H).
5)
Remove the springs (I) and the bearings (J). Remove the roller
(K).
(K).
6)
Pull out the shafts (L) from rear side.
* When installing, be careful to the installing direction of the
* When installing, be careful to the installing direction of the
shafts. First of all, insert the side where the tip of the shaft
each is steps.
each is steps.
Unit
Parts
Mainte
nance
1
Fusing unit
I
Web unit
✕ ▲
1-I
A
A
B
B
C
D
E
F
G
H
K
I
J
J
I
L
L
Click on the first or last page to see other MX-6201N / MX-7001N (serv.man39) service manuals if exist.