Read Sharp MX-6201N / MX-7001N (serv.man39) Service Manual online
MX-7001N FUSING SECTION O – 11
6)
Remove the screws (L), and remove the clamp (M) and the
harness holder (N). Disconnect the connectors (O) with
release each locks (P).
* When installing, be careful to the wiring.
harness holder (N). Disconnect the connectors (O) with
release each locks (P).
* When installing, be careful to the wiring.
7)
Remove the screws (Q) and the lamp holders (R). Remove the
heater lamps external (S).
* When installing the heater lamp external (T), voltage nota-
heater lamps external (S).
* When installing the heater lamp external (T), voltage nota-
tion side (U) is the rear side.
8)
Remove the screw (U) and the clamp (V), and disconnect the
connectors (W). Remove the screws (X), and remove the
external heat roller unit (Y) from the shaft (Z).
connectors (W). Remove the screws (X), and remove the
external heat roller unit (Y) from the shaft (Z).
9)
Remove the external heat springs (a). Remove the E-rings (b),
and remove the slider rings (c), the lever F (d), and the lever R
(e).
Remove the slider rings (f) from the lever F (d) and lever R (e).
* When installing the external heat spring, be careful to the
and remove the slider rings (c), the lever F (d), and the lever R
(e).
Remove the slider rings (f) from the lever F (d) and lever R (e).
* When installing the external heat spring, be careful to the
installing direction.
10) Remove the screws (g), and remove the external heat roller
unit (h). Remove the external heat bearings (i).
11) Remove the external heat collars (j), and the external heat belt
(k) from the external heat rollers (l).
O
O
M
L
P
L
N
Q
R
R
Q
S
S
1-l
1-l
T
T
X
Z
X
Y
U
V
W
W
b
c
1-n
1-n
b
c
e
d
e
d
1-n
f
f
1-n
1-m
a
1-m
a
g
g
i
i
1-o
1-o
h
l
l
j
j
k
1-p
1-p
1-r
1-r
1-q
Click on the first or last page to see other MX-6201N / MX-7001N (serv.man39) service manuals if exist.