Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man75) Service Manual online
MX-7000N MX-FXX1 13 – 3
C. Removal of the control box
1)
Remove the screw of right rear cabinet, push down the right
rear cabinet. Disengage the pawls, and remove the right rear
cabinet so that slide to the front side.
rear cabinet. Disengage the pawls, and remove the right rear
cabinet so that slide to the front side.
2)
Remove the screws of control box. Raise the finger handle,
and pull out the control box slowly.
and pull out the control box slowly.
3)
Pull out the control box until the position in which the clamp is
seen. Remove the HDD-IDE cable from the clamp.
seen. Remove the HDD-IDE cable from the clamp.
4)
Pull out the control box until the position in which the connector
of the HDD-IDE cable is seen. Pull the sheet, and remove the
HDD-IDE cable.
of the HDD-IDE cable is seen. Pull the sheet, and remove the
HDD-IDE cable.
D. Attach the FAX memory
1)
Install the FAX memory (Package part No. 4) to the socket on
the MFP PWB as shown in the figure below so that the mem-
ory notch (A) is on the right side.
the MFP PWB as shown in the figure below so that the mem-
ory notch (A) is on the right side.
E. Connection of the I/F cable
1)
Insert the control box until the connectable position for HDD-
IDE cable, connect the HDD-IDE cable.
IDE cable, connect the HDD-IDE cable.
2)
Insert the control box until the position that fix the HDD-IDE
cable to the clamp, put the HDD-IDE cable to the sheet (A),
and fix it to the clamp.
* Check that the HDD-IDE cable is not twisting, hanging
cable to the clamp, put the HDD-IDE cable to the sheet (A),
and fix it to the clamp.
* Check that the HDD-IDE cable is not twisting, hanging
down, etc.
3
4
1
2
1
1
2
2
3
1
2
1
2
BOOT
BARCODE
PCL/BUMON
PS KANJI
PROGRAM2
PROGRAM1
FAX IMG EXT
A
1
2
1
A
2
3
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man75) service manuals if exist.