Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man75) Service Manual online
MX-7000N MX-FXX1 13 – 6
3)
Use the numeric keys to enter [10] in the sub-code entry
screen shown below and press the [START] key.
screen shown below and press the [START] key.
4)
In the submenu screen shown below, press [EXECUTE] on the
touch panel.
After [YES] on the panel lights up, press it.
touch panel.
After [YES] on the panel lights up, press it.
5)
The screen shown below is displayed and memory clear oper-
ation is executed.
ation is executed.
6)
After several minutes, memory clear operation is completed
and the [YES] button goes out. Press the [CA] key to exit from
the simulation mode.
Then the main unit is automatically rebooted.
and the [YES] button goes out. Press the [CA] key to exit from
the simulation mode.
Then the main unit is automatically rebooted.
K. Connection of the line cable
1)
Connect the line cable (Package part No. 1) of the line side to
the modular jack indicated with “LINE”.
the modular jack indicated with “LINE”.
• After connecting, be sure to carry out the "External phone
connecting" setting of the system settings (administrator).
• For using an external telephone, wind the line cable around
the supplied ferrite core (Package part No. 5) by two turns
and connect the cable to the modular jack indicated with
"TEL".
and connect the cable to the modular jack indicated with
"TEL".
FAX SOFT SW. SETTING.
FAX SOFT SW. CLEAR.
FAX PWB MEMORY CHECK.
SIGNAL OUTPUT CHECK. (LEVEL MAX)
LINE
TEL
Appro
x. 10
cm
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man75) service manuals if exist.