MX-5500N, MX-6200N, MX-7000N (serv.man32). MX-LCX2 LCT A4-Installation Manual - Sharp Copying Equipment Peripheral (repair manual). Page 8

MX-7000N  MX-LCX2  2 – 8

Execute SIM 26-2 "Size setting" with the key operations of the main
unit.
1)

The size selection menu of the large capacity tray is displayed
on the operation message display.

2)

Select the number (Size to set) on the message screen, and
input the key.

Since the off-center adjustment has been made at shipping, there
is normally no need to adjust. However, if the center is shifted,
carry out the following steps to adjust.
1)

Set a test chart (document) on the document table properly.

2)

Execute SIM 50-10 (Print off center) by the key operation of
the main unit.

3)

In SIM 50-10, the display is shown as follows to allow setting of
the print off-center adjustment value for each paper feed tray.

[When shifted to the front side]
To adjust the print line in the direction A from the paper center as
shown in the figure, increment the number of value. Then make a
copy to check to insure that there is no more shift. Repeat the pro-
cedures until there is no shift.

[When shifted to the rear side]
To adjust the print line in the direction B from the paper center as
shown in the figure, decrement the number of value.

Then make a copy to check to insure that there is no more shift.
Repeat the procedures until there is no shift.
* For details of the adjustment and checking procedures, refer to

the "[6] ADJUSTMENT" on the Service Manual for main unit.

Since the off-center adjustment is performed when shipping, there
is basically no need to perform this adjustment. If the center is
shifted, however, the simulation is normally used. If the shift is not
removed, perform the following adjustment procedure
1)

Pull out the large capacity tray gently until it stops.

A

BK-MAG

Main scan print magnification ratio BK

100

B

MFT

Print off-center adjustment value (Manual 
paper feed)

50

C CS1

Print off-center adjustment value (Tray 1)

50

D CS2

Print off-center adjustment value (Tray 2)

50

E

CS3

Print off-center adjustment value (Tray 3)

50

F

CS4

Print off-center adjustment value (Tray 4)

50

G LCC

Print off-center adjustment value 
(LCC)

50

H ADU

Print off-center adjustment value (ADU)

50

I

MULTI COUNT

Number of print

1

J

PAPER

MFT

Tray selection

1 : Manual paper feed

2

CS 1

2 : Tray 1

CS 2

3 : Tray 2

CS 3

4 : Tray 3

CS 4

5 : Tray 4

LCC

6 : LCC

K

DUPLEX

YES

Duplex 
selection

0 : Selection

1

NO

1 : Unselection

R side

Center line of image (first image

ȫ

F side

(Fig. 1)

R side

Center line of image (first image

ȫ

F side

(fig. 2)