MX-5500N, MX-6200N, MX-7000N (serv.man32). MX-LCX2 LCT A4-Installation Manual - Sharp Copying Equipment Peripheral (repair manual). Page 5

MX-7000N  MX-LCX2  2 – 5

<<How to separate the large capacity tray from the main
unit>>
1)

Turn the lock release screw of the front cover clockwise and
tighten the screw securely to release lock.

2)

Then hold the grips of the front and the rear cabinets with both
hands, and lift the left side. The large capacity tray will come
off.

1)

After installing the large capacity tray to the main unit, loosen
the screws (one in the front and one in the rear) of the adjust-
ment caster mounting plate attached to the lower side of the
large capacity tray.
At that time, the casters of the adjustment caster mounting
plate are brought into contact with the floor by the spring force.

2)

Tighten the screws (one in the front and one in the rear) of the
caster mounting plate which were loosened in procedure 1).

1)

Remove the fixing screws (one for each) from the connector
cover on the main unit and then remove the two connector
covers.

2)

Connect the large capacity tray interface harness connector
(a) and the heating heater interface harness connector (b) to
the main unit connector, and tighten the connector screw to fix
the connector.

Since the factory setting of the paper size is A4, if paper size switch
is required, perform the following procedures.
1)

Pull out the large capacity tray until it stops.

F side

R side

a

b