MX-5500N, MX-6200N, MX-7000N (serv.man18). MX-FNX3 4 MX-RBX2 MXPNX2A-D SERVICE MANUAL-Disassembly Assembly-1 - Sharp Copying Equipment Peripheral (repair manual). Page 37

MX-FNX4  DISASSEMBLY AND ASSEMBLY  6 – 37

3) Remove the two screws [6], open the harness holder [7] at

three positions, and disconnect the connector [8] at two posi-
tions.

4) Insert your finger into the hole in the back of the No. 1 tray [9].

Push the tray lift motor gear [10] toward you to release the
clutch, and lift the No. 1 tray [9].

CAUTION: When the clutch of the tray lift motor gear is released, it

falls by its own weight. When releasing the clutch, there-
fore, hold the tray at the bottom in advance. When
installing it, take care not to twist the tray cable.

CAUTION: Note for installing or moving the tray

When moving down the tray, push up the shutter [1],
and release the latch [2] on the lower surface of the tray
to lower the tray.
When the latch is released, the tray will free-fall. Hold
the tray with your hand during the removal.

1)

Remove the screw [1], and remove the stopper [2].

2)

Remove the two screws [3], and disconnect the connector [4].

3)

Insert your finger into the hole in the back of the No.2 tray [5].
Push the tray lift motor gear [6] toward you to release the
clutch, and lift the No.2 tray [5].

CAUTION: When the clutch of the tray lift motor gear is released, it

falls by its own weight. When releasing the clutch, there-
fore, hold the tray at the bottom in advance. When
installing it, take care not to twist the tray cable.

[7]

[8]

[6]

[6]

[9]

[10]

[2]

[1]

[2]

[1]

[4]

[3]

[3]

[5]

[6]