MX-4100N, MX-4101N, MX-5000N, MX-5001N (serv.man38). Installation Manual-(Complete Manual) - Sharp Copying Equipment Service Manual (repair manual). Page 12

MX-4100N  MX-4100N/4101N/5000N/5001N  1 – 9

1)

Install the Operation Manual storage (package part No. 8)
cover to the left side of the machine.
a)

First, insert the pawl on the lower side of the Operation
Manual pocket.

b)

Then, lift the pawl on the upper side and insert it, and slide
down to install.

* If the MX-FN10 (saddle finisher) is installed together with

installation of the machine, the Operation Manual storage
cover must be installed to the saddle finisher.

Change the tray setting in the "system setting" mode. If "Disabling
of Tray Settings" has been enabled in the system settings (adminis-
trator), the tray settings (except for the bypass tray) cannot be con-
figured.
1)

Press the [SYSTEM SETTINGS] key.

2)

Touch the [Paper Tray Settings] key.

3)

Touch the [Paper Tray Settings] key to configure the settings.
These settings specify the paper type, paper size, and func-
tions allowed for each paper tray. When the [Tray Settings] key
is touched, a list appears showing the trays and the current
settings.

4)

Touch the [Change] key in the above screen to change the set-
tings. The following settings can be configured.

1)

Pull out the paper tray.
Gently pull the tray out until it stops.
If paper remains in the tray, remove it.

2)

Adjust the guide plates A and B by squeezing their lock levers
and sliding them to match the vertical and horizontal dimen-
sions of the paper to be loaded.
The guide plates A and B are slidable. Slide each guide plate
while squeezing its lock lever.

1

1

2

Type

Select the type of paper that is loaded in the tray. 
The paper types that can be selected vary by paper 
tray.

Size

Select the paper size from the list. The paper sizes 
that can be selected vary by tray. The sizes that 
can be selected may also be restricted by the paper 
type selected above. 
If the desired size does not appear in the list, select 
[Custom Size] and directly enter the size (only for 
the bypass tray).

Feeding Approved 
Job

Select the modes that can be used. If there is a 
function that you do not wish to be used with the 
selected tray, disable the function. When the "Type" 
is other than plain paper, recycled paper, colored 
paper, or a user type, [Fax] and [Internet Fax] 
cannot be selected.

B

A