Read Sharp MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man148) Technical Bulletin online
2)
The above error message is displayed for 10 sec. Then the following message is displayed.
3)
Then the following message is displayed to indicate that a HDD trouble occurred.
When the above messages are displayed, the HDD is broken down. Turn OFF the main power and replace the HDD with a new one.
b.
Work contents and procedures
Procedures
When a new HDD
(blank HDD, service part) is
used, or when a HDD which
is normal but a program
error occurs in it is used.
When a used HDD
(used in the same
model) is used *
Step 1
Reinstall the firmware
(program) in the boot mode.
Use SIM49-1 to reinstall
the firmware (program).
Step 2
Install a HDD to the machine,
and boot the complex
machine.
Formatting is
automatically performed.
Install a HDD to the
machine, and boot the
complex machine.
,
e
d
o
c
e
l
b
u
o
rt
e
h
T
4
p
e
t
s
o
T
3
p
e
t
S
U2-05, is displayed.
Cancel with SIM16.
Step 4
Since a blank HDD is
automatically formatted, there
is no need to perform
formatting procedure with
SIM.
Use Sim62-1 to format
the HDD.
Step 5
Use SIM66-10 to clear the FAX image memory. The
memory is cleared in order to keep compliance between
the HDD data and the image related memory and to
prevent malfunctions. (The memory must be cleared not
only in the FAX model but in the scanner and the Internet
Fax models.)
Step 6
Use SIM49-3 to install the manual data to the HDD.
Step 7
The trouble code, U2-60 is displayed Use SIM49-5 to
install the watermark data to the HDD. After booting
the machine. Use Sim16 to cancel the U2-60 trouble
the machine. Use Sim16 to cancel the U2-60 trouble
With the above procedures, the HDD is reset to the state of factory shipping.
(4)
HDD replacement and firmware installation (version up)
a.
Operations and displays after HDD replacement
When a new HDD without the main program in it or a normal HDD with abnormal main program data in it is installed to the machine and the
main power is turned ON, the following operations and displays are made.
1)
When the power is turned ON, the main program error is displayed.
2)
The above error message is displayed for 10 sec. Then the following message is displayed.
3)
The machine enters the boot mode which indicates that there is an error in the main program.
b.
Operations in the boot mode
When the machine is booted in the boot mode, the firmware version check, the firmware install, and the version-up operation can be
performed.
When a HDD is installed to the machine and the above operation is performed, the firmware must be installed.
When a HDD is installed to the machine and the above operation is performed, the firmware must be installed.
*
In the boot mode, the following keys are used for operation. Note that the functions of the keys in the boot mode differ from those in the
normal mode.
Click on the first or last page to see other MX-4100N / MX-4101N / MX-5000N / MX-5001N (serv.man148) service manuals if exist.