Read Sharp MX-2300N / MX-2700N / MX-2300G / MX-2700G / MX-2300FG / MX-2700FG (serv.man11) Service Manual online
MX-RPX1 ADJUSTMENTS 8 – 4
End of the
adjustment
adjustment
Yes
Yes
No
No
Check section B.
The bosses in section A
and B are excessively
pressed. (The right side
is separating.)
and B are excessively
pressed. (The right side
is separating.)
Adjust hinge E
until there is a
resistance in
section B.
(Clockwise)
until there is a
resistance in
section B.
(Clockwise)
Adjust hinge E
until the
separation in
section C is
deleted.
(Counter-
clockwise)
until the
separation in
section C is
deleted.
(Counter-
clockwise)
Is
there a re-
sistance?
c)
Check section B.
Place the RSPF height adjustment sheet between section B
and the SPF glass height adjustment resin surface (a), and
close the RSPF unit.
and the SPF glass height adjustment resin surface (a), and
close the RSPF unit.
Slowly pull out the RSPF height adjustment sheet.
Check to insure that a slight resistance is felt when pulling out
the RSPF height adjustment sheet.
the RSPF height adjustment sheet.
e)
Check section C.
Check to confirm that the projection in section C in the right
front side of then RSPF bottom is in contact with the glass
surface (b).
front side of then RSPF bottom is in contact with the glass
surface (b).
d)
If it cannot be pulled out or there is no resistance to pull out,
turn section E to adjust.
turn section E to adjust.
* Turn section E clockwise to lift the RSPF unit. Turn it
counterclockwise to move down the RSPF unit.
a
B
b
E
b
C
b
C
Is there
a separating
section.
Check section C.
* Be careful not to put the book sensor (b) on the height
adjustment sheet.
Click on the first or last page to see other MX-2300N / MX-2700N / MX-2300G / MX-2700G / MX-2300FG / MX-2700FG (serv.man11) service manuals if exist.