Read Sharp DM-2000 (serv.man8) Service Manual online
B. MCU
Note:
● When replacing the MCU PWB, replace the EEPROM in the
MCU PWB which is to be replaced.
● When replacing the MCU PWB, check that the Flash ROM is
of the latest version. (SIM 22-14)
If the Flash ROM is not of the latest version, perform version
up according to the attached “Flash ROM version up proce-
dures (No. XXX).”
If the Flash ROM is not of the latest version, perform version
up according to the attached “Flash ROM version up proce-
dures (No. XXX).”
C. Printer control PWB
Note:
● When replacing the printer control PWB, check that the
firmware is of the latest version.
If the firmware is not of the latest version, perform the version
up procedures described later.
If the firmware is not of the latest version, perform the version
up procedures described later.
6. Optical frame unit
No.
Content
A
Optical frame unit
A. Optical frame unit
Installation: Install the optical unit in the sequence shown above.
(2)
(3)
(2)
(4)
(5)
(6)
(1)
(1)
(2)
(2)
(1)
(1)
(3)
(1)
(1)
(1)
(1)
(2)
(1)
(2)
(3)
DM-2000
11 – 7
Click on the first or last page to see other DM-2000 (serv.man8) service manuals if exist.