Read Sharp AR-SP10 Service Manual online
AR-SP10/RP10 ADJUSTMENTS
– 6 –
3. Document off center adjustment
Note: When performing this adjustment, check that the paper off-center
is properly adjusted.
1) Set the center position adjustment test chart (made by yourself) on
the SPF (RSPF).
<Adjustment specifications>
Draw a line in the center of paper. (In the scanning direction)
2) Make a normal copy from the manual feed tray, and compare the
copy and the test chart.
If an adjustment is required, perform the following procedures.
If an adjustment is required, perform the following procedures.
3) Execute SIM 50-12.
4) The current off-center adjustment value is displayed on the display
section in two digits.
5) Enter the set value and press the START key.
The entered correction value is started and a copy is made.
<Adjustment specifications>
4. Image lead edge position adjustment
1) Set a scale on the OC table as shown below.
2) Make a copy, and use the copied paper as the document and make
a copy from SPF (RSPF) again.
3) Check the copied paper. If an adjustment is required, perform the
following procedures.
4) Execute SIM 50-6.
5) Set the SPF/RSPF lead edge position set value so that the image
5) Set the SPF/RSPF lead edge position set value so that the image
similar to the adjusted image at the OC image lead edge position
described previously is printed.
described previously is printed.
<Adjustment specifications>
Mode
Specification
SIM
Set value
Set
range
Document
off-center
(AR-RP10)
off-center
(AR-RP10)
Simplex:
Center
±
3.0mm
Duplex:
Center
±
3.5mm
SIM 50-12
TEXT:
TEXT:
SPF surface
PHOTO:
SPF back
Add 1:
0.1mm shifted to
R side.
R side.
Reduce 1:
0.1mm shifted to
L side.
L side.
1 ~ 99
Document
off-center
(AR-SP10)
off-center
(AR-SP10)
AUTO:
Surface
TEXT:
SPF surface
Adjustment
mode
SIM
Set value
Specification
Set
range
Image
lead edge
position
lead edge
position
SIM 50-6
AUTO:
AUTO:
Front
TEXT:
Back
PHOTO:
Rear edge
1step:
0.1mm shift
Lead edge void:
1 ~ 4mm
Image loss:
3mm or less
1 ~ 99
Note: Since the printed paper is used as the test chart,
place the scale in parallel to both sides.
Click on the first or last page to see other AR-SP10 service manuals if exist.