Read Sharp AR-RF3 (serv.man2) Service Manual online
AR-RF3 UNPACKING AND INSTALLATION 2 - 3
(5) Attach the exit tray.
Attach the exit tray to the right side of the RADF.
∗∗∗∗
If another peripheral device must be installed, carry out the fol-
lowing steps at the end of the installation work.
lowing steps at the end of the installation work.
Insert the power plug of the main unit to the outlet and turn on the main
switch.
switch.
Since adjustment has been made at shipping, adjustment is normally
not needed here. If the center or original front end should be displaced,
however, carry out the following steps to adjust.
not needed here. If the center or original front end should be displaced,
however, carry out the following steps to adjust.
(6) Carry out the off center adjustment.
Place an original in the document feeder tray and make a copy.
If the center of the copy is displaced as shown in Fig. 1 or Fig. 2,
loosen the two tray securing screws and move the document feeder
tray in direction A or direction B to adjust the center.
loosen the two tray securing screws and move the document feeder
tray in direction A or direction B to adjust the center.
After adjustment is complete, be sure to tighten the tray securing
screws.
screws.
• In the case of displacement shown in Fig. 1
Loosen the two tray securing screws and move the document feeder
tray in direction A.
tray in direction A.
Tighten the two tray securing screws and make a copy again to
check that the center is not displaced.
check that the center is not displaced.
• In the case of displacement shown in Fig. 2
Loosen the two tray securing screws and move the document feeder
tray in direction B.
tray in direction B.
Tighten the two tray securing screws and make a copy again to
check that the center is not displaced.
check that the center is not displaced.
(7) Adjust the original front end stop position.
• The original front end stop position can be adjusted with simulation
53.
• Although the stop position is set to (8) at shipping, adjustment may
be needed depending on the original.
• The adjustable range is 8 mm toward the original size indicator plate
and 7 mm toward the document glass. The position can be adjusted
in 1 mm increments. The adjustment can be set for the single-sided
mode and the two-sided mode respectively.
in 1 mm increments. The adjustment can be set for the single-sided
mode and the two-sided mode respectively.
• Use the touch panel and the keys on the main unit to set the mode.
• Then use the touch panel and the keys on the main unit to perform
various settings.
Tray securing screws
B
A
Index
Fig. 1
Fig. 2
Center line of paper
Center of image
(first image)
(first image)
Center line of paper
Center of image
(first image)
(first image)
0
10 11 12 13 14 15
2
3
4
5
6
7
9
1
8 mm
7 mm
Original size indicator plate
Document glass
Viewing from operator side
5
CA
3
1
CA
[Touch panel]
[Touch panel]
[Key operation]
[Key operation]
0
9
OK
The value is registered.
Input a numerical value using the
numeric keys. (0 to 15 can be set.)
numeric keys. (0 to 15 can be set.)
The machine returns to the
previous mode.
previous mode.
Select
A: Single-sided ordinary paper or
B: Two-sided ordinary paper for
condition setting.
A: Single-sided ordinary paper or
B: Two-sided ordinary paper for
condition setting.
Click on the first or last page to see other AR-RF3 (serv.man2) service manuals if exist.