AR-RF3 (serv.man2). AR-RF3 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 3

AR-RF3  UNPACKING AND INSTALLATION  2 - 2

1) Cut and remove the two cut-out portions from the rear of the upper

cabinet of the main unit using a tool such as diagonal cutting tool.

2) Attach the two RADF mounting screws to the mounting holes pre-

pared in 1).

3) Lift the B/W scanner module/DSPF, fit the holes in the hinge sec-

tions of the B/W scanner module/DSPF to the RADF mounting
screws that have been attached in 2), move the B/W scanner mod-
ule/DSPF toward the front, and secure it with the two RADF secur-
ing screws.

Loosen the two angle adjusting plate securing screws on the hinge
angles. While raising the angle adjusting plates to the limit as shown in
the illustration, tighten the loosened screws.

Note: Be sure to check that the projections on the angle adjusting

plates are inserted securely into the long holes of the hinges.

1) Remove the screw from the connector cover on the rear side of the

main unit and then remove the connector cover.

2) Connect the RADF connector to the connector of the main unit and

tighten the screw on the connector to secure it.

Cut-out portions

RADF mounting screw

RADF mounting screw

RADF securing screw

RADF securing screws

RADF mounting screw

Angle adjusting plate

Hinge angle

Long holes

Angle adjusting
plate securing
screws

Connector cover

RADF connector

Screw