Read Sharp AR-PE3 (serv.man4) Service Manual online
27
System software
Installing system software over the network port
To install system software using the network port on the Fiery X3e, you need:
• Either:
• One Category 5 Ethernet cross-over cable (8-wire, short-length)
or
• One Ethernet network hub or switch that supports 100BaseTX
• Two Category 5 Ethernet network cables
• A computer with:
• Windows XP/2000
• A CD-ROM drive, built in or attached
• Support for 100BaseTX
• Approximately 500MB of disk space free, if you copy the files to your computer’s
hard disk
T
O
INSTALL
SYSTEM
SOFTWARE
USING
THE
NETWORK
PORT
C
AUTION
:
Wear an ESD grounding wrist strap and follow standard ESD (electrostatic
discharge) precautions while performing this procedure.
1.
With the Fiery X3e and the print engine powered off, flip the service switches to service
mode (toward from the motherboard).
mode (toward from the motherboard).
To access the service switches and reassemble the Fiery X3e, use the procedure on
page 26.
page 26.
2.
Connect the Fiery X3e network port to the computer network port by performing one of
the following tasks:
the following tasks:
• Attach a short Category 5 Ethernet cross-over cable to the network port of the
Fiery X3e and of the computer.
or:
• Attach a Category 5 network cable to the Fiery X3e and to an isolated hub/switch;
attach another Category 5 network cable to the computer and to the isolated
hub/switch.
hub/switch.
N
OTE
:
Do not connect any other devices to the hub/switch. Do not put the hub/switch
on the LAN. Do not use the hub’s optical port or uplink switch.
3.
Power on the computer and insert the System Software CD into the computer’s
CD-ROM drive.
CD-ROM drive.
Normal (away from
the motherboard)
the motherboard)
Service (toward the
motherboard)
motherboard)
Click on the first or last page to see other AR-PE3 (serv.man4) service manuals if exist.