Read Sharp AR-PE3 (serv.man4) Service Manual online
28
System software
4.
Navigate to the CD-ROM drive and click the icon for Install.exe.
For a faster installation, you can copy the files from the CD to the computer and then
perform the installation from the computer’s hard disk. You must copy all CD files to the
computer’s hard disk. Choose a location that will not mix the CD files with any other
files. Make sure to delete the files when you are finished with the installation.
perform the installation from the computer’s hard disk. You must copy all CD files to the
computer’s hard disk. Choose a location that will not mix the CD files with any other
files. Make sure to delete the files when you are finished with the installation.
5.
Power on the print engine and the Fiery X3e.
The message, “INITIALIZING PRINT CONTROLLER. PLEASE WAIT.” appears on
the Control Panel.
the Control Panel.
N
OTE
:
Ignore the message “PLEASE TURN OFF THEN ON THE PRINT
CONTROLLER POWER SWITCH” if it appears on the Control Panel during
this procedure.
this procedure.
6.
When the message, “INITIALIZING PRINT CONTROLLER. PLEASE WAIT” appears on the
Control Panel, click Start on the computer installer screen. Read the Software License
Agreement and click Agree to continue the installation process.
Control Panel, click Start on the computer installer screen. Read the Software License
Agreement and click Agree to continue the installation process.
7.
Wait while the files are copied and installed. Click Exit when the message is displayed
that the installation was successful. Remove the System Software CD.
that the installation was successful. Remove the System Software CD.
The progress is slow at first. For most computers, expect to wait approximately 25
minutes. If you click Abort, you must to power off the print engine and the Fiery X3e
and wait 10 seconds before repeating this procedure. If the installation terminates
abnormally, reboot the computer also.
minutes. If you click Abort, you must to power off the print engine and the Fiery X3e
and wait 10 seconds before repeating this procedure. If the installation terminates
abnormally, reboot the computer also.
N
OTE
:
After the progress bar reaches 100%, a time-out error may occur if the interface is
erroneously reporting that the number of bytes to copy is equal to the number of bytes
copied. If this happens, ignore the time-out error and proceed as if you received the
message that the installation was successful.
copied. If this happens, ignore the time-out error and proceed as if you received the
message that the installation was successful.
8.
With the Fiery X3e and the print engine powered off, flip the service switches to normal
mode (away from the motherboard).
mode (away from the motherboard).
To access the service switches and reassemble the Fiery X3e, use the procedure on
page 26.
page 26.
9.
Dismantle the isolated Ethernet network between the Fiery X3e and the computer by
removing the cross-over cable from the Fiery X3e and the computer (or the two network
cables from the Fiery X3e, the computer, and the isolated hub/switch).
removing the cross-over cable from the Fiery X3e and the computer (or the two network
cables from the Fiery X3e, the computer, and the isolated hub/switch).
10.
Reconnect the Ethernet network cable to the Fiery X3e and to the customer’s LAN
(see page 24). Do not use the cross-over cable.
(see page 24). Do not use the cross-over cable.
11.
Power on the print engine and the Fiery X3e and allow the Fiery X3e to boot up.
The language screen appears on the Control Panel when the Fiery X3e starts up.
12.
Press the name of the language you want to use, and then press OK.
Normal (away from
the motherboard)
the motherboard)
Service (toward the
motherboard)
motherboard)
Click on the first or last page to see other AR-PE3 (serv.man4) service manuals if exist.