Read Sharp AR-PE2 (serv.man34) Technical Bulletin online
Sharp Electronics (UK) Ltd., NIS Systems Support
NIS Bulletin054
Page: 3 of 4
5. Click Port Settings and ensure that “Spool MS-DOS print jobs” and “Check
port state before printing” are selected as shown below.
6. Click Apply and OK to activate the settings and exit from the Printer
properties screen.
7. Shut down the Fiery AR-PE2 and power off the copier.
8. Connect an IEEE 1284 centronics cable to the LPT1 port on your PC and to
the parallel port on the Fiery AR-PE2.
9. Insert the CD containing the system software files into the CD Rom Drive.
The files can be downloaded by either copying the files onto the PC’s Hard Disk
drive or directly from the CD drive where Hard Disk space is limited.
drive or directly from the CD drive where Hard Disk space is limited.
10. Using the Windows “Start” menu, open a MS-Dos window by selecting
“Programs” and “MS-Dos” prompt.
Note:
Do NOT use the option “Shut Down and Restart Windows in DOS mode”.
11. At the MS Dos prompt, navigate to the Directory to where the files are
located (CD Rom or HDD).
Two files are required for installing the system software:-
Part 1 (Boot)
Part 2 (Main Program)
12. Type the following Command at the MS Dos prompt but DO NOT
press the enter key at this stage.
COPY/B PART1 LPT1:
13. Power on the copier and within 3 seconds (just after the transport belt
advances), press the enter (return) key on the PC.
The Dos window on the PC will display a “One File Copied” message.
The Dos window on the PC will display a “One File Copied” message.
14. When the copier indicates a “Ready to Copy” status, enter the Fiery menu
by executing the PRINT key, taking the copier OFFLINE and pressing the
FIERY Logo in the upper right corner of the copier LCD screen.
FIERY Logo in the upper right corner of the copier LCD screen.
Click on the first or last page to see other AR-PE2 (serv.man34) service manuals if exist.