Read Sharp AR-NC5J (serv.man7) User Guide / Operation Manual online
5-10
Using in Macintosh Environment
Print Server Card
Users Manual
Configure Other Protocols
PSC Setup Utility can also setup parameters of other protocols.
If you are using Print Server Card for Macintosh environment only, you do not need to setup
the following protocols.
Configuring TCP/IP
When you click
TCP/IP, setup screen for TCP/IP protocol opens. The description for each
section is as below.
Use TCP/IP Protocol:
Enable or disable TCP/IP protocol. This setting affects the operation of LPR, FTP, TELNET,
SNMP, HTTP, and setup utilities, etc.
Use DHCP/BOOTP:
Enable or disable DHCP/BOOTP protocol. DHCP/BOOTP is the protocol to obtain an IP
address from the DHCP or BOOTP server when booting. A properly configured DHCP or
BOOTP server must be working correctly in the subnetwork to assign IP Address to Print
Server Card by DHCP/BOOTP. Print Server Card recognizes DHCP and BOOTP
automatically and adopts the first reply as its own IP address.
Use RARP:
Enable or disable RARP protocol. RARP is the protocol to obtain IP address from RARP
server in booting. A properly configured RARP server must be working correctly in the
subnetwork to assign the IP address of Print Server Card by RARP.
IP Address:
Assign IP address to Print Server Card. The value must be configured in the format of four-
part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx".
Subnet Mask:
Assign a subnet mask to Print Server Card. The value must be configured in the format of
four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx". If the
value is "0.0.0.0," this setting is invalid.
The subnet mask corresponding to the IP address will be assigned automatically.
Click on the first or last page to see other AR-NC5J (serv.man7) service manuals if exist.