Read Sharp AR-NC5J (serv.man7) User Guide / Operation Manual online
5-11
Using in Macintosh Environment
Print Server Card
Users Manual
Default Gateway:
Assign the IP address of Print Server Card’s gateway. The value must be configured in the
format of four-part series of numbers separated by decimal points, such as "xxx.xxx.xxx.xxx".
The gateway must be in the network where Print Server Card exists. If the value is "0.0.0.0",
this setting is invalid.
Use FTP/LPR Banner:
Enable or disable banner page when LPR or FTP is used to print.
Configuring NetWare
When you click
NetWare, setup screen for NetWare protocol opens. The description for
each section is as below.
Use NetWare Protocol:
Enable or disable NetWare protocol.
Print Server Name:
Specify the print server name for Print Server Card to boot in print server mode. Because this
configuration is used as the identifier on the network in the NetWare protocol, the print server
name must be different from other names in the NetWare environment. It is used as a login
name in connecting to the NetWare server.
Frame Type:
Select the default frame type of Print Server Card. If the selected frame type does not work,
the frame type will be changed to another type automatically.
Operation Mode:
Select the primary operation mode (print server/remote printer) of Print Server Card. If the
selected mode does not work, Print Server Card boots in the other mode.
Click on the first or last page to see other AR-NC5J (serv.man7) service manuals if exist.