Read Sharp AR-NC5J (serv.man5) User Guide / Operation Manual online
7-12
Print Server Card User Software
Print Server Card
Users Manual
Configure TCP/IP
Go to menu bar of NICManager and select
Setup - Print Server Card Setup and move to
TCP/IP. This section is a very important part of set up. Check with your network administrator
before setting up.
<Explanation for Each Parameter>
Use TCP/IP Protocol:
Enable or disable TCP/IP protocol. This setting will influence the use of LPR, FTP, TELNET, SNMP, HTTP and
Setup Utility (for TCP/IP).
Use DHCP/BOOTP:
Enable or disable DHCP/BOOTP protocol. This is a protocol that acquires IP address from DHCP/BOOTP
server when booted. In order to use this function with Print Server Card, a DHCP/BOOTP server must exist in
the network and properly set up. Print Server Card will automatically acknowledge DHCP and BOOTP and use
the first corresponding IP address.
Use RARP:
Enable or disable RARP. RARP is a protocol that acquires IP address from RARP server when booted. In order
to use this function with Print Server Card, a DHCP/BOOTP server must exist within the same subnetwork and
properly setup.
IP Address:
Setup IP address. The value must be configured in the format of four part series of numbers separated by
decimal points, such as ”xxx.xxx.xxx.xxx”.
Click on the first or last page to see other AR-NC5J (serv.man5) service manuals if exist.