Read Sharp AR-NC1D (serv.man3) User Guide / Operation Manual online
Hardware Installation-2
2.2
Connect the Network to Print Server Card: Ethernet
You can connect your
Ethernet
network in one of two ways:
1.
Using the 10BaseT or 100BaseT Ethernet interface
. This network connection
uses a 4-wire RJ cable to plug into the RJ45 network connector on the Print
Server Card.
Server Card.
Note:
The Print Server Card automatically determines which type of network connec-
tion you are making; 100BaseT,10BaseT, or 10Base2. However, some older
10BaseT hubs may not support auto-detection of 10BaseT versus 10Base2. If this
occurs, you may be required to change a jumper from automatic to manual selec-
tion. See
Appendix A
for details.
2.
Using a Thinnet Ethernet interface
. Your Print Server Card may include a BNC
connector for 10Base2 or Thinnet connection. The Thinnet Ethernet wire uses a
BNC T-connector to plug into the BNC port on the Print Server Card (marked
Thinnet
on the bracket). This Ethernet cable is 1/4-inch coaxial cable (usually
RG-58/U) that uses the cylindrical BNC T-connector to attach to the BNC port.
Once you make the connection, continue to
2.3 Powering Up the Printer,
Click on the first or last page to see other AR-NC1D (serv.man3) service manuals if exist.