Read Sharp AR-M620 (serv.man161) Technical Bulletin online
Sharp Electronics (UK) Ltd., Technical Services Group
ARE722
5-1. Pull out the separator pawl shaft from the hole of the process unit by sliding it to the
rear side, and pull away from the separator pawl shaft earth spring at the same time.
5-2. Pull out the separator pawl shaft from the hole of the process unit by sliding it to the
front side.
6. All four of the e type rings and SP pins of the separator pawl shaft are removed, once
removed replace the separator pawl shaft cap with the new separator pawl shaft pick.
6-1. Remove the e type rings, separator pawl shaft caps and pins, this process is
repeated four times.
7.
After inserting the SP pin until it ends protrudes to the one side, the separator pawl
shaft pick can be inserted, this process is repeated four times.
shaft pick can be inserted, this process is repeated four times.
Click on the first or last page to see other AR-M620 (serv.man161) service manuals if exist.