Read Sharp AR-M35 / AR-M450 (serv.man11) Service Manual online
AR-M350 UNPACKING AND INSTALLATION 6-2
2. Note for installation place
Improper installation may damage this product. Please note the following
during initial installation and whenever the machine is moved.
1) The machine should be installed near an accessible power outlet for
1) The machine should be installed near an accessible power outlet for
easy connection.
2) Be sure to connect the power cord only to a power outlet that meets
the specified voltage and current requirements. Also make certain
the outlet is properly grounded.
•For the power supply requirements, see the name plate of the main
unit.
3) Do not install your machine in areas that are:
•damp, humid, or very dusty
•exposed to direct sunlight
•exposed to direct sunlight
•poorly ventilated
•subject to extreme temperature or humidity
changes, e.g., near an air conditioner or heater.
4) Be sure to allow the required space around the machine for servicing
and proper ventilation.
3. Unpacking procedure
Check the following items are included in the package.
4. Machine installing procedure
Note: In advance to installation of the machine, the paper feed option
units (AR-D13 or AR-D14) should have been installed.
A. Removal of the machine
1) Remove the cushioning materials from the right and left of the front
side.
2) Remove the locking tape from the right and left sidesof the tray.
Then,Remove the top of the carton and lower the plastic bag
covering the machine while the machine is still on the carton base.
3) Remove the packing tape from the paper tray, pull out the paper tray
until it stops and remove it by tilting it upward.
4) One person must lift by the empty front tray pocket with the right
hand and steady the machine with the left hand placed at the upper
left of the machine.
left of the machine.
The other person must lift with the right hand by using the lifting
recess in the rear of the machine and also steady the machine with
the left hand as shown in the illustration.
the left hand as shown in the illustration.
Note: The center of gravity of the machine lies in the left side when
viewed from the Back of machine. When lifting the machine, be
careful not to drop it.
Developer
Toner cartridge for installation
CD-ROM for AR-350/450 series printers
Operating Manual
Counter kit contract
31-1/2"
(80cm)
23-5/8"
(60cm)
23-5/8" (60cm)
11-13/16" (30cm)
1
1
1
1
1
4
4
3
2
3
Front side
Rear side
) "# $%&'(
Click on the first or last page to see other AR-M35 / AR-M450 (serv.man11) service manuals if exist.