Read Sharp AR-M35 / AR-M450 (serv.man11) Service Manual online
AR-M350 UNPACKING AND INSTALLATION 6-6
E. Setting related to fusing
1) Put down the right and the left levers of the fusing unit in the arrow
direction.
F. Paper setting
1) Pull out the first stage paper feed tray.
Slowly pull out the tray until it stops.
2) While pressing the paper holding plate, remove the fixing pin.
3) Put paper in the tray, and close the paper feed tray.
5. AR-EF1 / AR-RK1
<Before installation>
•For installation, an MFP control board (AR-M11) is needed.
1) Assemble the rack.
Insert two racks A securely all the way into two racks B respectively
as shown in the illustration and use four screws (M4 x 8) respectively
as shown in the illustration and use four screws (M4 x 8) respectively
to secure the racks in the order of <1> to <2> in the illustration.
2) Cut the rear cabinet of the desk unit.
Cut the cut-off portions on both ends of the rear cabinet of the desk
unit by hand and remove them.
unit by hand and remove them.
Parts included for the rack
Screws (M4 x 8)
(8 pcs.)
Screws (M3 x 6)
(2 pcs.)
Cam A securing screw
(M3 x 12) (1 pc.)
M4 stepped screws
(3 pcs.)
Screws (M5 x 70)
(4 pcs.)
Racks A
(2 pcs.)
Shaft
(1 pc.)
Cam A
(1 pc.)
Tray
(1 pc.)
Cam B
(1 pc.)
Racks B
(2 pcs.)
Parts included in
the scanner unit
Rack sheet: 1 sheet
Racks B
Racks A
Screws
M4 x 8
Screws
M4 x 8
1
1
2
2
Cut-off portions
"# $%&'(
Click on the first or last page to see other AR-M35 / AR-M450 (serv.man11) service manuals if exist.