AR-M316 (serv.man18). Key Operator's Guide - Sharp Copying Equipment User Guide / Operation Manual. Page 20

This program is used to set the method for switching 
printer ports.
The machine can use the following three printer ports:

• Parallel port
• USB  port
• Network port

The factory default setting is "SWITCH AT END OF 
JOB".

This program is used to enable or disable printing via 
the parallel port.
This program is initially enabled (factory default 
setting).

This program is used to enable or disable printing via 
the USB port.
This program is initially enabled (factory default 
setting).

This program is used to enable or disable printing via 
the network port.
This program is initially enabled (factory default 
setting).

Enable this program when you wish to use ECP mode 
on the parallel port.
This program is initially disabled (factory default 
setting).

The NETWORK SETTINGS are used when the 
machine is used as a network printer. The "NETWORK 
SETTINGS" consist of the following programs:

● IP ADDRESS SETTING

● ENABLE TCP/IP

● ENABLE NetWare 

● ENABLE EtherTalk 

● ENABLE NetBEUI 

● RESET THE NIC

This program is used to set the IP address (IP 
address, Subnet Mask, and Gateway) of the machine 
when TCP/IP protocol is used on the network.
When "DHCP" is selected, the machine will obtain an IP 
address automatically. This is the factory default setting.
When the machine is used on a TCP/IP network, be 
sure to enable the "ENABLE TCP/IP" program.

This program must be enabled to use the machine on 
a TCP/IP network. "IP ADDRESS SETTING" must 
also be configured.
This program is initially enabled (factory default setting).

This program must be enabled to use the machine on 
a network that uses NetWare protocol.
This program is initially enabled (factory default setting).

SWITCH AT 
END OF JOB

Automatic printer port selection 
at the end of each print job.

SWITCH AFTER 
I/O TIMEOUT

Automatic printer port selection if 
the time set in "I/O TIMEOUT" 
elapses.

Consult your network administrator 
before configuring the NETWORK 
SETTINGS.

• After changing the settings, you must turn 

off the machine’s power switch, wait 
briefly, and then turn the switch back on in 
order to make the changes take effect.

• Some programs in the following are 

marked by "*1". This indicates that a 
message will appear at the end of the 
setting procedure asking you to confirm 
execution of the new setting. If needed, 
you can cancel the new setting by 
touching the [NO] key.

This setting is only effective in a  network 
environment that uses Ipv4 TCP/IP protocol. 
To set an IP address on a Ipv6 TCP/IP 
network, use the Web pages. In an IPv6 
environment, the machine can use LPD or 
IPP protocol.

AR-M318_keyope_uk.book  18 ページ  ２００７年１月１１日　木曜日　午後２時４４分