AR-M165-207 (serv.man74). Supply of service part for countermeasure against image distortion in the trailing edge of the back side. - Sharp Copying Equipment Technical Bulletin (repair manual). Page 3

Read Sharp AR-M165-207 (serv.man74) Technical Bulletin online

 
 
 
Sharp Electronics (UK) Ltd., Document Systems Support
 
 
 
 
If distortion has occurred in the trailing edge of the back side (see figure below), attach 
one or  
more Mylar sheets to the FU pressure lever F or R with reference to the table below. 
 
 Note: 
The above reference table for number of Mylar sheets was made up based  
on the test results in the production plant. 
However, use this table as a guide since the effect varies depending on the  
machine status or the used paper. 
When the effect is small, attach one more Mylar sheet, and check the effect. 
If the effect is too large (the line is distorted in the reverse direction of the  
initial pattern), remove the Mylar sheets on a sheet-by-sheet basis. 
 
Page of 3
Display

Download Sharp AR-M165-207 (serv.man74) Technical Bulletin