AR-FX2 (serv.man2). AR-FX2-Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 9

6) Install the Fax key unit.
● Connect the flat cable to the machine connector and fold the flat

cable under the FAX key unit. Fix the Fax key unit with screws.

7) Stick the supplied label.
● After removing the protective sheet from the operation panel, stick

the supplied label to the left of the exposure indicators.

8) Attach the ground wire.
● Reattach the ground wire to the operation panel with the screw.

Check that the ground wire is securely squeezed by the aluminum
sheets.

9) Attach the operation panel of the copier machine.
● Attach the flat cable and fix with a screw.
Note: Before attaching the flat cable, release the connector lock and

insert the cable. After attachment, lock the connector.

10) Attach the front cover to the copier.
● Warp the front cover by pressing the both sides, and attach it to the

hinge arm of the machine. After attaching the paper tray, close the
side cover and the bypass tray.

11) Remove the rear cabinet of the machine.
● Remove the document cover. Remove the screw and remove the

rear cabinet.

12) Remove the shield plate of the copier.
● Remove the screw.

13) Attach the PWB mounting frame.
● If a ground plate is present, remove it and attach the PWB mounting

frame by aligning the two positioning locators and using the supplied
M3 screws (silver color) as shown in the illustration.

Note: Check that the AC cord is passed under the projection (

★) as

shown in the figure. If not, loosen the AC cord holder screws,
and pass it under the projection, then tighten two screws.

[For the U.K.]

[For Australia]

M3 8

M3 8

M3 8

Blue line-must be up

If an open/close detector 
is present, take care not 
to break the actuator.

Positioning locators

Ground plate

Blue line-must be up

AR-FX2

3  –  2