AR-FX2 (serv.man2). AR-FX2-Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 11

21) Attach the ground plate.
● Fit the two hooks to the ground plate and secure the plate with M3

screws(gold).

22) Attach the rear cabinet of the machine.
● Cut off the notch section in the rear cabinet with nippers so that the

cut surface is flat. Attach the FAX connector cover.
Fix with the screw and attach the document cover.

23) Time setup check
● Change the time setup referring to the SIM 26-22

24) Stick the label to the rear cabinet of the copier.
[For Australia]
Stick the A-Tick label to the position shown in the illustration.
In order to manifest the compliance with Australian Communications
Authority, please put the A-Tick label, packed with the kit, on the
prescribed location after installing the FAX expansion kit in the
machine.
After installing this kit to the product, stick the supplied A-Tick label to
the specified location.

[For the U.K.]
Stick the CTR21 label to the position shown in the illustration.
In order to comply with the Pan-European requlation CTR21, please
put the label, packed with the kit, on the described location after install-
ing the FAX expansion kit in the machine.
After installing this kit to the product, stick the supplied CTR21 label to
the specified location.

1) Remove the FAX connector cover with a screwdriver. 
2) Insert the memory card so that the model name is on the back.
3) Attach the FAX connector cover.

M3x6

M3x6

M3x6

M3x6

 M3 x 8 for steel

M3x6

M4 x 10 for plastic

 M3 x 8 for steel

FAX connector cover

Power off position

Power on position

(1)

(1)

(2)

(3)

(3)

5mm

A-Tick Label

Reference line

5mm

CTR21 Label

Reference line

AR-FX2

3  –  4