AR-FN1 (serv.man7). ARFN1 Service Manual-Adjustment - Sharp Copying Equipment Service Manual (repair manual). Page 3

The following table shows the main parts requiring adjustment at the
time of replacement 

Item

Part name 

1

Jogger F/R 

2

Paper entry gate solenoid 

3

Reversion roller pressure release solenoid 

4

Paper discharge gate solenoid 1 

5

Paper discharge gate solenoid 2 

6

Paper discharge gate solenoid 3 

7

Short path switching solenoid 

8

Tray 3 upper limit solenoid 

Note: Remove or install parts in numerical order shown in the follow-

ing figures. 

A. Let the unit staple 5 sheets of A4 or letter paper and check the

bundle of the sheets for deviation in directions A).

B. When the deviation in directions A) is are within 1 mm, there is no

need to adjust the jogger F/R.

C. When the deviation exceeds 1 mm, adjust the jogger F/R accord-

ing to the simulation 3-6: Adjusting Finisher Jogger Position.

The screen above is displayed after the sub number of the simulation
is entered. 

1) Adjust the value with the numeric keypad.

2) The joggers in the finisher are operated by pressing the [EXE-

CUTE] key. The [EXECUTE] key is displayed in reverse video
during loading operation.  When the [EXECUTE] key in this state
is pressed, loading operation can be canceled.

Condition

Adjusting procedure 

1

When the deviation in the
direction A) exceeds 1 mm.

Decrease the simulation value.
(Decreasing the simulation by
1 narrows the width between
the joggers by 0.63 mm.)

Increase the simulation value.
(Increasing the simulation value
by 1 widens the width between
the joggers by 0.63 mm)

Note: The width between joggers can be visually checked by observ-

ing the label inside the staple tray.

A)

Pin

A

Jogger

Label

Letter position

Jogger

A4 position

The spacing between
labels is 0.5 mm.

6 – 1