Read Sharp AR-CF1 (serv.man7) Service Manual online
6-11
CHAPTER 6 MECHANICAL CONSTRUCTION
Figure 6-126
3.
Removing the Buffer Roller
Assembly
Assembly
1) Remove the finisher controller PCB (see I-
C-1).
2) Remove the feed drive unit (see I-B-2).
3) Remove the screw [1], and remove the guide
3) Remove the screw [1], and remove the guide
support plate assembly [2] to slide out the
harness leads [3] towards the buffer roller
assembly side.
harness leads [3] towards the buffer roller
assembly side.
Figure 6-127
Caution:
Before re-attaching the removed feed drive
unit back on the finisher unit, loosen the
move gear stop screw [8] to relieve the
tension, and then fasten the screw after
attaching the feed drive unit.
The move gear attachment must be adjusted
also when removing and attaching the
swing unit.
If you forget to fasten the screw, the gear
teeth may disengage, resulting in defective
feed.
unit back on the finisher unit, loosen the
move gear stop screw [8] to relieve the
tension, and then fasten the screw after
attaching the feed drive unit.
The move gear attachment must be adjusted
also when removing and attaching the
swing unit.
If you forget to fasten the screw, the gear
teeth may disengage, resulting in defective
feed.
[8]
[1]
[2]
[3]
4) Remove the three screws [6], and remove
the feed drive unit [7].
Figure 6-125
[6]
[6]
[6]
[7]
Click on the first or last page to see other AR-CF1 (serv.man7) service manuals if exist.