Read Sharp AR-C330 (serv.man4) Service Manual online
AR-PE3/PX5 - 2 -
5) Open the scanner (reading) unit and fix it with the hold shaft.
6) Remove the interface cabinet.
7) Remove the cover plate on rear cabinet.
Removed screw is used for attach the printer I/F card.
8) Attach the printer I/F card with the cover plate fixing screws.
Connect the Wake Up signal harness and fix it with the snap
band.
band.
9) Attach the I/F cover with seven screws (M4 x 6). Pass the
Wake Up signal harness through the wire clamp.
10) Connect two I/F cables. Remove the screw of the ICU cover,
and fix the harness clamp and the I/F cable with the removed
screw.
screw.
11) Fix two screws (M4 x 8) temporarily, and install the printer
power unit temporarily. Fix the above two screws securely and
fix one additional screw (M4 x 8). Connect the connector and
fix with the snap band.
fix one additional screw (M4 x 8). Connect the connector and
fix with the snap band.
Click on the first or last page to see other AR-C330 (serv.man4) service manuals if exist.