AR-C262M (serv.man20). Operation Manual (Key-Operator) - Sharp Copying Equipment User Guide / Operation Manual. Page 18

After the [EXECUTE] key is touched and a test patch
printed, a message appears asking you to begin
automatic adjustment. Place the test patch on the
document glass as shown below and touch the
[EXECUTE] key.

When a message appears informing you that auto
colour calibration is completed, touch the [OK] key to
end the procedure.

The resolution for copying in black and white from the
reversing automatic document feeder can be changed
from 600 x 300 dpi to 600 x 600 dpi (high quality mode).
When high quality mode is used, fine print and thin
lines are reproduced with greater clarity, however, the
scanning speed is slower. If you prefer a faster
scanning speed, do not enable high quality mode.
When high quality mode is not selected, the following
conditions must be satisfied in order to scan at 600 x
300 dpi and attain the fastest speed.

Conditions for fast job speed (all must be satisfied):

• The copy ratio must be set to 100%
• AUTO, TEXT, TEXT/PRTD.PHOTO, or TEXT/

PHOTO must be selected for the exposure, and
neither "COPY OF COPY" nor "COLOUR TONE
ENHANCEMENT" are selected.

• When using a special function, only the following

special functions can be used with 600 x 300 dpi
resolution:

MARGIN SHIFT, ERASE, CENTRING,
TRANSPARENCY INSERTS, COVERS, MIRROR
IMAGE, EXTRA SIZE

"Enable/Disable settings" consists of the following
programs:

● Disabling deletion of job programs
● Disabling of bypass-tray in duplex copy
● Disabling of covers mode
● Disabling of auto paper selection

This program is used to prevent stored programs from
being replaced or deleted. When this program is set,
storing of job programs is also disabled.

This program is used to disable the use of the bypass
tray when making duplex copies.
The bypass tray is sometimes used to feed heavy
paper. Loading heavy paper in the duplex module/2 x
500 sheet paper drawer may cause a misfeed or
failure. If heavy paper is frequently used, it is
recommended that you enable this program.

This program is used to prevent selection of the
COVERS mode.

This program is used to prevent automatic paper
selection. When automatic paper selection is disabled,
the copier will not automatically select a paper tray
containing paper that matches the size of the original
placed on the document glass or in the reversing
automatic document feeder.

Lay approximately five sheets of copy paper that
are the same size as the test patch on top of the set
test patch, and gently close the document cover.

Before executing this program, check to see if the
registration adjustment is correct. If not, execute
[AUTO ADJUSTMENT] in [Registration
adjustment] on page 12.

Cyan

Magenta

Yellow

Black

whale2_keyope_ex.fm  16 ページ  ２００４年９月２１日　火曜日　午後３時３４分