AR-C262M (serv.man20). Operation Manual (Key-Operator) - Sharp Copying Equipment User Guide / Operation Manual. Page 14

This program is used to adjust the stapling position
(folding position) when using the saddle stitch function
of the optional saddle stitch finisher.
The value can be adjusted in 0.1 mm increments within
±3.0 mm from the reference position for each paper
size.

[AUTOMATIC SADDLE STITCH] checkmark
The saddle stitch print function can normally be divided
into the following three general steps.
1. The pages of the original are automatically

reordered to allow saddle stitch binding (saddle
stitch function).

2. The pages are folded at the centre.
3. The paper is stapled at the centre in two places

(saddle stitch stapling).

The [AUTOMATIC SADDLE STITCH] checkbox is
selected by default.
Selection of the checkbox assumes the use of the
above saddle stitch printing function (three steps).

Saddle stitch stapling exceptions
Depending on the purpose of saddle stitch stapling, it
may be necessary to perform saddle stitch stapling on
printed matter that has already been bound by saddle
stitching. In this case, it is necessary to disable step 1
above. If you frequently perform this type of
exceptional saddle stitch stapling that requires
disabling step 1, remove the checkmark from the
[AUTOMATIC SADDLE STITCH] checkbox.

This program is used to enable the stream feeding
mode of the document feeder. When the stream
feeding mode is enabled, additional originals which are
set in the document feeder tray within 5 seconds after
the previous original was fed will be fed and copied
automatically.

Use this program to select the paper type* for which the
automatic paper selection function operates.
Selections are "Plain paper", "Plain paper and recycle
paper", and "Recycle paper".
* The paper type set for each paper tray in the paper

tray settings of the user settings (page 2-11 of the
"Operation Manual (for general information and
copier operation)").

Use this program when the colour of characters and
lines in colour printing is off. Registration adjustment
can be performed in two ways: manually and
automatically. Normally [AUTO ADJUSTMENT]
should be used.

● [AUTO ADJUSTMENT]

Touch this key to have registration adjustment
performed automatically.
After touching this key, touch the [EXECUTE] key. A
message appears when automatic registration
adjustment is completed. Touch the [EXIT] key to
exit.

● [MANUAL ADJUSTMENT]

Touch this key to perform registration adjustment
manually.
Use this key when you require a higher level of
precision than can be obtained with [AUTO
ADJUSTMENT]. See page 13 for the procedure for
manual registration adjustment.

1

2

12

11

Min. -3 mm

Max. +3 mm

Reference position

Position adjusted 
to the plus 
direction

Position adjusted 
to the minus 
direction

The stream feeding mode will not function when the
covers mode has been selected.

whale2_keyope_ex.fm  12 ページ  ２００４年９月２１日　火曜日　午後３時３４分