Read Sharp AR-810 (serv.man24) Service Manual online
AR-651/810 CONTROL PANEL 5 - 5
5. 2. 2. Display in abnormal condition
No.
Message
1
Add paper
2
Add toner
Press [HELP]
3
Set key copy
counter
4
Paper misfeed in
bypass
5
Misfeed in copier
Press [HELP]
6
Misfeed in copier
Press [HELP]
7
Misfeed in doc.
feeder
Press [HELP]
8
Misfeed in finisher
Press [HELP]
9
Misfeed in
INSERTER
10
Call for service
11
Time for periodic
maintenance
12
Check paper in LCF
13
—
14
Select the same
sized Tab sheets as
the originals
Abnormal state and indication on display panel
Paper run out [Fig.5.2-1 A]
- The cassette with no paper flashes.
Toner run out [Fig.5.2-2 B]
- The toner cartridge is empty.
- The message is displayed and the copier is
stopped.
Key copy counter not installed [Fig.5.2-1 C]
- The key copy counter was pulled out when
copier was ready for scanning.
- The copier is stopped when the key copy
counter is pulled out after the [START] key
was pressed.
Bypass paper jam [Fig.5.2-2 D]
- Paper jam at the bypass tray
Paper jam in the copier [Fig.5.2-2 E]
Misfeeding of cassette paper [Fig.5.2-2 F]
- Paper fed from the cassette does not reach
the feed sensor in a fixed time.
Original jam [Fig.5.2-2 G]
- Original jamming in RADF
Paper jam in the finisher [Fig.5.2-2 H]
Paper jam in the inserter [Fig.5.2-2 I]
Motors, sensors, switches, etc. do not work
properly. [Fig.5.2-2 J]
PM cycle
- Time for maintenance
- Copying is possible.
Paper misloading in the tandem LCF
- Displayed when a paper is set out of alignment
Toner bottle full
- The toner bottle is full of used toner.
The copier stops its operation. [Fig.5.2-2 K]
Displayed when the paper sizes for the tab
sheets and originals are different
Solution
- Add paper to the cassette.
- Select a different cassette.
- Replace the toner cartridge and close
the front door.
- Insert the key copy counter (option).
- Remove the paper from the bypass
tray.
- Press the [HELP] key and remove the
paper following the messages
shown on the display panel.
- Press the [HELP] key and remove the
paper following the messages
shown on the display panel.
- Open the jam-access cover and
RADF unit to remove the original.
- Press the [HELP] key and remove the
paper following the messages
shown on the display panel.
- Press the [HELP] key and remove the
paper following the messages
shown on the display panel.
- Turn OFF the power and solve the
problem, then turn ON the power again.
- Maintenance and inspection are per-
formed by a qualified service techni-
cian.
- Set the paper correctly.
- Replace the toner bag with a new
one and close the front cover.
- Select the same size for tab sheets
and originals.
Click on the first or last page to see other AR-810 (serv.man24) service manuals if exist.