Read Sharp AR-810 (serv.man24) Service Manual online
AR-651/810 CONTROL PANEL 5 - 3
No.
Message
State of copier
Note
12
READY
(SADDLE STITCH
TRAY FULL)
13
READY
(SET CORRECT
CASSETTE)
14
READY (ADDING
TONER)
15
READY (CHECK
STAPLER)
16
READY (CHECK
SADDLE STITCH
STAPLER)
17
READY (USE
GENUINE SHARP
TONER)
18
ENTER DEPART-
MENT CODE
19
READY (ADD
INSERTER PAPER)
20
READY (ADD TAB
SHEET)
21
READY (FINISHER
IN USE)
Ready for scanning
- The copier is ready for scanning and waiting
for the operator to select the copying conditions.
The saddle stitcher is full of paper.
Ready for scanning
- The copier is ready for scanning and waiting for
the operator to select the copying conditions.
Correct size cassette not installed during printing
Ready for scanning
- The copier is ready for scanning and waiting
for the operator to select the copying
conditions.
Copier is adding toner to the DV.
Ready for scanning
- The copier is ready for scanning and waiting for
the operator to select the copying conditions.
The finisher unit is out of staples.
Ready for scanning
- The copier is ready for scanning and
waiting for the operator to select the
copying conditions.
The saddle stitcher unit is out of
staples.
Ready for scanning
- The copier is ready for scanning and
waiting for the operator to select the
copying conditions.
Toner other than Sharp’s has been used.
The copier is waiting for the operator to
enter the department code.
- Displayed when the department manage-
ment function has been used
Ready for scanning
- The copier is ready for scanning and
waiting for the operator to select the
copying conditions.
No inserter paper
Ready for scanning
- The copier is ready for scanning and
Ready for scanning
- The copier is ready for scanning and
waiting for the operator to select the
copying conditions.
copying conditions.
No tab paper
Ready for scanning
-The copier is ready for scanning and
waiting for the operator to select the
copying conditions.
Finisher manually operating
Printing is resumed by removing pa-
per from the saddle stitcher unit.
- Printing is resumed by changing
the setting for cassette selection,
then pressing the [START] key.
- Printing is resumed automatically
when the toner supply is completed.
- Printing is resumed automatically
when the staple cartridge is
replaced with a new one.
- Printing is resumed automatically
when the staple cartridge is
replaced with a new one.
The display is made to disappear by
using the toner provided by Sharp.
The copier becomes ready to start
copying when the correct depart-
ment code is entered.
Printing is resumed when the
[START] key is pressed under the
condition the printing UI is displayed
([JOB STATUS] key pressed) after
adding inserter paper.
Printing is resumed when the
[START] key is pressed under the
condition the printing UI is displayed
([JOB STATUS] key pressed) after
Printing is resumed when the
[START] key is pressed under the
condition the printing UI is displayed
([JOB STATUS] key pressed) after
adding tab paper.
Printing is started when pressing the
[START] key.
Click on the first or last page to see other AR-810 (serv.man24) service manuals if exist.