AR-280 (serv.man12). AR280 285 335 Service Manual-Simulation Codes - Sharp Copying Equipment Service Manual (repair manual). Page 8

Code

Function (Purpose)

Purpose

Section

Item

Main

Sub

26

18

Used to set VALID/INVALID of toner save
operation. (This simulation is valid only in
the Japan and UK versions. (It depends
on SIM 26-6 (Destination setting). For the
other destinations, the same setting can
be executed with theuser program.)

Setting

Specifications

Operation
mode
(Common)

22

Used to set the specification (language
display) for the destination. (Target
models: AR-280/285/335) (Excluding the
Japan models.)

Setting

Specifications

26

Used to select between the auto power
shut off mode and the power save mode.

Setting

Specifications

Operation
mode
(Common)

30

Used to set the operation mode for heater
lamp slow up control CE mark.

Setting

Specifications

Operation

mode
(Common)

32

Used to set the RPM of the fan motor un
the low speed rotation mode (ready
condition).

Setting

Others

Operation

35

Used to set whether the trouble history
display of SIM 22-4 is displayed as one
trouble or as the number of continuous
troubles when two or more troubles of a
same kind occured.

Setting

Specifications

Operation
mode
(Common)

36

Used to set the IC fan operating
temperature. (Operation in pre-heat mode.)
(Excluding Japan models.)

Setting

ICU

Operation

27

1

Used to set the operation  specifications
when a communication trouble occurs
between the host computer  and MODEM
(on the copier). (When a communication
trouble occurs between the host computer
and MODEM (copier), the self diag display
(U7-00) is printed and setting is made to
select inhibit/allow of printing.)

Setting

Communication unit
(TEL/LIU/MODEM etc.)

Specifications

Operation
mode
(Common)

2

Used to set and change the host
computer/MODEM numbers. (This setting
is required when a communication is
made between the copier and a computer
through MODEM.)

Setting

Communication unit
(TEL/LIU/MODEM etc.)

Data

User data

3

Used to set and change the host
computer/MODEM numbers. (This setting
is required when a communication is
made between the copier and a computer
through MODEM.)

Setting

Communication unit
(TEL/LIU/MODEM etc.)

Data

User data

4

Used to enter the start time and the end
time of servicing for management of
service work. (The data can be checked
by the host computer.)

Setting

Communication unit
(TEL/LIU/MODEM etc.)

Data

5

Used to enter the TAG No. of the copier.
(This simulation allows to check the
machine TAG No. with the host
computer.)

Setting

Communication unit
(TEL/LIU/MODEM etc.)

Data

30

1

Used to check the operation of sensors
and detectors in the sections other than
the paper feed section of the copier and
the related circuit. (The operation of
sensors and detectors can be monitored
with the LCD.)

Operation test/check

Others

Operation

2

Used to check the operation of sensors
and detectors in the paper feed section
and the related circuits. 
(The operations of sensors and detectors
in the paper feed section can be
monitored with the LCD.)

Operation test/check

Paper transport

Operation

40

1

Used to check the operation of the
manual paper feed tray paper size
detector and the related circuit. (The
operation of the manual paper feed tray
paper size detector can be monitored with
the LCD.)

Operation test/check

Paper transport

Operation

2

Used to adjust the manual paper feed tray
paper width detector detection level.

Adjustment

Paper transport

Operation

8 – 6